It is the port, where a diagnostic machine can be hooked up. The diagnostic will read codes from your vehicles computer. For instance if your check engine light comes on, you can plug the diagnostic machine into the data port and it will tell you why the check engine light came on so that you can get it fixed.
The low pressure port on a 1990 Ford van is in the rear of the engine compartment. It is on the passenger side, near the firewall.
OBD Data port / data link??
It should be located under the dash on the drivers side.
According to Ford TIS technical data it is 200nm
The ODB II port is almost universally directly under the steering column and at the bottom edge of the dashboard - easily accessible from the front.The 1997 Ford Taurus OBD 2 port is on lower edge of dashThe 1997 Ford Taurus OBD 2 port is on lower edge of dash
port
The 1998 Ford E3 50 low pressure air conditioning port is located on the air conditioning compressor. The low pressure port will be on the right hand side of the compressor.
Its under the hood dead center under the front cowl cover with a black protected cover......
where is the ac recharge port on a 93 ford explorer located?
On a 1993 Ford E250 van, the diagnostic port, also known as the OBD-I connector, is typically located under the dashboard, near the driver's side. It can be found to the left of the steering column, close to where the dashboard meets the steering wheel. You may need to crouch down or use a flashlight to see it clearly. This port is used for connecting diagnostic tools to read trouble codes from the vehicle's onboard computer.
Fuse # 23 is a 20 amp fuse for the Data Link Connector and cigarette lighter
how does computer send data through serial port?