0

Subjects>Auto>American Cars

What is a x5 axle code on a 1997 ford crown vic?

Anonymous

∙ 12y ago

Updated: 10/25/2022

On a 1997 Ford Crown Victoria :

Axle code X5 is a ( 3.27 ratio , limited slip )

Wiki User

∙ 12y ago

What else can I help you with?

Related Questions

What is the axle ratio on 1997 ford ranger with an axle code of 95?

8.8 inch 3.55ratio open not limited slip

What is axle code cs on 1997 f250 club cab 4x4?

I was looking at the 1997 Ford F-250 Heavy Duty owners manual and there is a " C 5 " axle code listed 4.10 ratio - limited slip manufacturer - Ford capacity - 6,250 pounds

What does axle code 19 mean on an 1997 E150 ford van?

Conventional non-Positraction Differential 3.55

Where is the axle ratio code for 2003 ford explorer?

On a 2003 Ford Explorer : Open the drivers door and there is an information sticker on the latch pillar You will find the axle code under " axle " Once you have the axle code you can determine the axle ratio

How do you replace the rear axle studs on a 1997 ford expedition?

take the axle out

What does axle code 19 mean on a 1995 Ford Bronco?

According to the ( 1996 ) Ford Bronco Owner Guide : Axle code ( 19 ) is a Ford conventional ( non Ford Traction Lok / limited slip ) axle with a 3.55 ratio

What is Ford axle code 82?

According to the 1996 Ford Ranger owners manual : Axle code 82 is a ( 3.08 conventional ) ( not a traction-lok )

What is ford axle code cg?

CG is 3.31

Where is the fuse located for the cigarette lighter on a 1997 Ford crown Victoria?

In a 1997 Ford Crown Victoria : Fuse ( # 16 ) is a 20 amp fuse for the cigarette lighter

What weight oil do you suggest for a 1997 Ford crown Victoria 8 cylinder?

The 1997 Ford Crown Victoria owners manual shows ( 5 w 30 )

How do you determine the rear axle ratio for a 2004 ford ranger?

I believe the axle code is listed on a sticker on the end of the drivers door The axle code will correspond to an axle ratio Once a person knows the axle code , the ratio can be looked up

1997 Ford Crown Victoria OBD?

The 1997 Ford Crown Victoria OBD 2 port is located under driver side dash next to center console

Trending Questions

How do you adjust a spark plug gap on a 1999 Alero? How much horsepower does a srt4 stage1 have? Speaker replacement in a 2005 Yukon? What kind of coolant should you use in your 1994 grand am se? How do you put coolant back in the radiator in a 2001 Pontiac Grand Am GT since there is no cap on the radiator.? How did route 66 get its name? Installed dual exhaust on 2000 Dodge Dakota but engine light comes on for the o2 sensor bank 1 How can you fix this Is there a better o2 sensor that works with dual exhaust? After having new tires and alignment on a 2001 Lincoln Navigator is it aligned properly if the steering wheel is tilted to the left while the car is going straight? Can you replace a windsield wiper lever without having to replace the whole switch on 95 geo metro and someone broke it off when they broke in your car any suggestions? What would burn out the computer on a 1987 dodge w150 half ton 318 4x4 truck? Did Chevrolet make a 1994 camaro ss? Is a 90 dodge acclaim with a 2.5 an interference engine? How do you replace a heater hose on a 1965 ford mustang? Why does your reverse lights flash when you shift into reverse in a 2006 Ford Escape? How many gallons does the gas tank in the 2004 Chevrolet Tahoe hold? How do you fix the diagnostic trouble code p1504 for 1999 Ford Taurus? Buick rendavous wont move when in drive? Where is the blower motor located on 1988 G20 chevy van? What engines can go into a Saturn Vue? Where is the fuse box location for 1994 previa?

Resources

Top Categories

Product

Company

Copyright ©2025 Answers.com. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.