answersLogoWhite

0

Clutch hydrauic problem with master,slave,line or check where the master connects to the clutch pedal for a missing bushing

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Why does a 1996 Kia Sportage with no prior heating problem run hot and hesitate to start or tries to turn over but does not when shut off after changing the timing belt and clutch fan?

check the water pump. I had the same problem.


What does Batman do when there is a problem?

He tries to fix it.


Pokemon Ranger guardian signs?

It's A new Pokemon ranger game that you play as a sky ranger a different kind of ranger that tries to stop the evil Pokemon pinchers but you get to see and capture a lot of legendary Pokemon and use signs to call them back


How does a scientist solve a problem?

he tries it again and again and again!


I'm driving a stick shift Dodge Neon When I stop the car the engine is still running very strong When starting to drive the car starts jumping and cant always accelerate?

This sounds like a slipping clutch. With the car in gear, fully depress the clutch pedal and give the car a little gas. If it tries to pull forward, then the clutch is not engaging properly. If this is the case, look into clutch and pressure plate repairs.


My 99 ford ranger xlt just lost power will not start tries to start up does not could that be the coil pack?

you need to pull a spark plug wire and hold it close to the engin see if it jumps when cranking. if not then you may have a coil problem. other wise you need to check fuel delivery.


What do you do if your hedgehog tries to escape?

If you have adequate housing, this will not be a problem. However, if the problem is that you do not have adequate housing for your pygmy, well, then, you need to get adequate housing. See the link for an article.


Why does your car smoke sometimes when you turn on the AC?

This could mean that your heater core is going bad. Had the same problem with my dodge ram 1500. It could also mean that the AC compressor clutch is slipping. It may only slip when it is first turned on because then it tries to goes from zero RPM to normal speed in a split second.


2000 gmc jimmy wants to shift into 4 wheel drive but does not have transmission problem could this electrical problem?

ive found that usuallu when the 4wd tries to engage on its own or wont come out of 4 wd it is usually bad switches in the pannel where you engage 4wd try puttin in 2wd and un plug the switch pannel if it stays in 2wd replace the switck pannel.


92 accord car died and thougtht it was the starter at first took it in the auto store said it was fine said the problem is the ignition switch i took ignition switch off looks good what is the problem?

There is no way to look at the switch and see if it's good, you'll need to use a meter to see if the starter output is working. If you have verified that the starter circuit is ok, next test the voltage at the starter when someone tries to engage the keyswitch. If you're sure the keyswitch is ok and there is no voltage to the starter, the only other options would be either a loose connection or a faulty neutral lockout switch if it's an automatic transmission or a clutch pedal sensor if it's a stick shift.


After a computer crashes and restarts what type of tool automatically runs and tries to determine a solution to the problem?

Startup Repair Tool


What if a UK non married women tries to get child support from an American man?

Assuming he is the biological father there should be no problem.