you have to remove the whole upper intake. i hate the 3.4 engine.
The best way to troubleshoot a malfunctioning thermostat for a baseboard heater is to first check the power supply, then inspect the thermostat settings and connections, and finally consider replacing the thermostat if necessary.
up Spring towards the engine.
The bulb end goes toward the engine.
the same way you replace it on any car you buy a chilton manual for your car and a thermostat and then follow the instuctions in the manual
Follow your top radiater hose,its inside the thermostat cover,2 bolts hold it on,put the new one in the same way as the old .
follow the bottom right hand pipe to underneath the engine remove pipe and then remove thermostat housing and replace thermostat the same way as it comes out.
What is the best way to change a device driver?
Drain the radiator down 1/2 way. At the engine end of the top radiator hose is the thermostat housing. Remove the housing and install a new thermostat.
Changing the tierod ends on a 1995 Honda Accord EX is a complicated process. Looking into the 1995 Honda Accord EX's manuel would be the best way to get instructions on how to change the tierod ends.
follow the top radiator hose to the engine, it will be attached to the therm housing, remove the therm housing and the you will see the thermostat, put it back the way you took it off
At the end of the upper radiator hose is where the thermostat is located as with all cars. It may be difficult to remove due to all this other crap that is in the way.
Whats the best way to change a starter on a 2001 silverado