0
What else can I help you with?
What is the standard height for deck railing?
The standard height for deck railing is typically 36 inches.
What is the size of the fuel tank on a 1997 ford contour GL?
i thinks its about 50 L because when i fill my cars tank it took 42L and there was already some in there.
How much is 42000 mL in L?
42L
What is the height of a boat called?
Height from the waterline to the deck is "freeboard." Above the deck is superstructure, and below the waterline is draft.
Is there a difference in cylinder deck height on Oldsmobile 371 and 394 engines?
It depends on the 371 your talking about the 57-58 371 is a raised deck height from the 54-56 324 engine. Then in 1959 they raised the deck height again so the 59-64 engines use the same deck height, which means the 59-60 371 engines being the last 371's share the same deck height as the 394 engines. Hope this helps you out.
What is the standard height requirement for a 2nd story deck railing?
The standard height requirement for a 2nd story deck railing is typically 42 inches.
How do you level lt155 deck?
To level the LT155 deck, start by ensuring the tractor is parked on a flat surface. Adjust the deck height to the desired position using the lift lever, then measure the height from the ground to the front and rear edges of the deck. If the front is lower than the rear, adjust the front deck hangers by raising them; if the rear is lower, lower the rear hangers. Make small adjustments and recheck the height until the deck is level.
Where and which is the highest bridge in th world?
The Sidu River Bridge in the province of Hubei lays claim to being the tallest in the world based on the height of its deck. The deck height is 1,627 feet, but its towers are not structurally taller than other bridges. A bridge that fits both the structural height as well as deck height is the Millau Viaduct. Its deck is 890 feet and the tallest of its towers are 1,125 feet.
How do you level cutting deck on Murray 42816A?
To level the cutting deck on a Murray 42816A lawn mower, first ensure the mower is on a flat surface. Then, adjust the deck height by locating the adjustment lever or knob on each side of the deck and setting them to the desired height. To check for levelness, measure the height from the ground to the front and back of the deck; they should be equal. If not, make further adjustments until both sides are even.
How do you tell the difference between a 302 ford and a 351 ford engine?
intake is wider on a 351 block is wider on 351First off do not confuse the 351 Windsor from the 351 Cleveland. The 351 Cleveland was produced from 1970 to 1975. You can tell them apart is several ways.The 302 deck height is 8.2" and the 351 deck height is 9.5". Older versions of the 351 had a deck height that was 1/2" higher than the 302.The VIN # on the vehicle the engine is mounted in will tell you if it is the OEM engine. The 8th digit of the VIN is the engine code. H means it is a 302, N means it is a 351.The engine displacement may be stamped on the valve cover or on the intake manifold.Look at the head bolts. The 302 head bolts are 7/16" diameter and the 351 are 1/2".The Intake on a 351 is wider than a 302 because the deck height is higher.
What is the deck height of the tacoma narrows bridge?
200 feet
What is a ship's height from waterline to main deck?
Ship's freeboard
