The hole in a compass, often found in the center of the compass rose, is typically used for mounting the compass on a pivot or for attaching it to a base. This allows the compass to freely rotate and align itself with the Earth's magnetic field. In some designs, the hole can also serve as a reference point for taking bearings or measurements.
It would be a hole punch.
There is a small hole below the compass button that allows for something small such as a paper clip... press and hold it and it will allow for you to configure the compass..
* Get a large, round piece of cardboard * Put a hole in the middle using a sharp pencil * Put the compass ticker in * Write on the directions * Place a layer of plastic/glass over the top
Use a compass to accurately draw the hole. Bore a hole thru the sheet metal big enough to allow pointed tin snips to start cutting. Follow the line with tin snips until the hole is completed.
It is called a compass. No, not like the kind with North, West, etc. but the math type. In most cases, you might hold your finger down in a certain place on the compass to keep it steady, then put a sharp pencil in a little hole (the closer to the center, the smaller your circle), and draw a circle with the pencil still in the hole. Hope this helps!
No,a Gyrosyn compass is a combination of a Magnetic compass and Direct reading compass.
compass
Compass compass compass
The plural of compass is compasses.
The prismatic compass is a type of compass use for survering a land.
idk i belive the compass
its called that because it is a compass that is golden