Intake manifold delivers the fuel air mixture to the cylinder heads, exhaust manifold collects the gases after combustion, and channels them into the exhaust pipe.
It sounds like you either have a leak at the exhaust manifold or the intake manifold. Most likely is the exhaust.
Its a bit of a job because it is held on by the same bolts as the intake manifold, and the easiest way is to remove them both, otherwise the rusted exhaust bolts holding the tubing to the manifold is the worst.
i have a 1998 ford Triton f 150 how do i remove the exhaust manifold right side
Intake manifold or exhaust? The complete job (parts and labor) is between $700-$900. depending on labor rates.
On most ford escorts, the oxygen sensor is located under the hood, on the exhaust manifold or the exhaust pipe. You'll have to look down between the engine and radiator.
To replace the exhaust manifold on a 1998 Plymouth Breeze 2.0, first disconnect the battery and remove any components obstructing access to the manifold, such as the air intake and heat shield. Unbolt the exhaust manifold from the engine block, taking care to remove any remaining gaskets or debris. Install the new manifold with a new gasket, tightening the bolts to the manufacturer's specifications. Finally, reassemble any components you removed and reconnect the battery.
What are the intake manifold torque specs for a 1998 ford f-150 xlt
It should be the same.. the standard jeep(left hand drive) the intake and exhaust are on the left side of the engine as well, so there is no need for a different manifold. so 99 % sure its the same manifold
What are the intake manifold torque specs on 1998 Oldsmobile bravada?"
it would be on the top of the moter
Passenger side of the intake manifold.Passenger side of the intake manifold.
The starter is located under the intake manifold and requires removal of the intake manifold to access it. Good luck!