0
What else can I help you with?
What is the rear end gear ratio in a 1986 cutlass supreme sedan?
what is the ratio of gears in a 1986 cutlass
Where is the fuel filter located on a 1989 Oldsmobile Cutlass Calais?
rear tire wall under car tw mills
Where is the fuel filter located on 2.5L 89 olds calais?
Under the rear of vehicle, just right of center.
Where is the low side service port to recharge ac on a 1997 Olds cutlass supreme?
The low side service port to recharge the AC on a 1997 Olds Cutlass Supreme is at the rear of the engine. It is close to the firewall.
What is the cable support bracket on rear disc brake caliper on a 93 olds cutlass?
e brake
How do you replace the rear license plate bulb on a 1996 Olds Cutlass Supreme?
The rear license plate bulbs on a 1996 Olds Cutlass Supreme are replaced by removing the retaining screws, pulling the light assembly out, and disconnecting the wiring harness. The bulb can then be twisted to remove it and a new bulb put in place.
Where is the fuel filter located on a 1990 Olds Cutlass Ciera?
under drivers side rocker panel before rear wheel
Where is Fuel filter on 1991 Olds Calais 2.3?
Should be mounted on the rear axle behind the fuel tank. About 1" diameter, 3" long.
Is there a 1972 Oldsmobile cutlass cs map light on the mirror option?
Yes, My 72 Olds Cutlass convertible came with the light option package which included a map light in the rear view mirror.
What causes rear rim to bond to hub on 1987 olds. cutlass calais and how to remove?
This happens when the metals bond from corrosion. Take a hammer, and give the back side of the rim a good wack, sping the rim a little bit, and give it another good wack, repeat until the rims comes loose from the hub.
What is the original gear ratio for a 1980 Oldsmobile Cutlass Supreme 4.3?
No cutlass supreme ever came with a 4.3. The olds 307 (5.0L) came with a th200 3 speed and 2.14 gear in the 80's. I believe there was another 2.xx gear offered but don't know which year or models. The hurst or 442 editions came with lower rear gears, around 3.73.
Can the rear end of a 1975 cutlass fit a 1970 cutlass?
No
