0
After replacing the battery in a 2007 Chevy Silverado, if the radio asks for a reset code, you typically need to consult the owner's manual or contact a dealership for the specific code, as it is unique to each vehicle. In many cases, simply driving the vehicle for a short period can reset the system. If the radio doesn't reset automatically, you may need to enter a code provided by an authorized dealer based on your vehicle's VIN.
What else can I help you with?
How do you reset using the battery a 1995 Chevy Lumina?
There is no battery reset.
How do you reset the check engine light on 03 Chevy Suburban after replacing the oxygen sensor?
disconnect the negative battery cable for 30 seconds
After replacing the battery in a Chevrolet Aveo how do you get the radio and clock to begin working again?
I had to take mine to the local Chevy dealer to get the code to reset the radio after the battery was changed. I was charged $40 by them to do this.
Do i have to Reset computer after replacing battery on 2002 Lexus LS 430?
No. Already reset.
How do you reset a smoke alarm after replacing the battery?
To reset a smoke alarm after replacing the battery, press and hold the test button on the alarm for a few seconds until you hear a beep. This will reset the alarm and ensure it is functioning properly.
Where is the reset button on the palm treo 755?
For Treos that do not have reset buttons, you can reset the phone by removing the battery and replacing it.
How do you reset the computer on a Chevy Trailblazer?
disconnect the battery
Why won't Rx-8 idle after replacing battery?
Computer reset
How do you reset the sentry key after replacing the 3.0V lithium battery for a 2005 Dodge Magnum?
No reset is necessary.
How do you reset system after replacing battery 99 mercury cougar?
There is nothing to reset except the radio presets and the clock.
How to reset check engine light on 2005 Chevy?
disconnect the battery for five minutes, It will reset
How do I reset cam shaft sensor on a 2001 Kia sportage?
always remove battery terminal when replacing sensors.That is your reset.
