You should begin by tightening the transmission and bolts on each corner of the transmission pan. Next, tighten the middle bolts on each side of the transmission pan. Work from the middle to the end, alternating from side to side.
The torque is 89 inch pounds or 7.41 foot pounds. You should never reuse a transmission gasket. If you are doing work on the transmission, replace the filter, it usually comes with a new gasket.
Could be either transmission pan Gasket, Axle Seals or torque convert seal, that's the seal that goes between torque convert and transmission.
There is no gasket between the engine and transmission. The torque converter inspection plate does have a dust seal on it.
usually no more than 35 ft lbs with new gasket
What is cylinder head torque specifications for 97 Chevy lumina 3.1 v6
Bad pump Bad torque converter
To replace the transmission gasket in a 1990 Geo Tracker, begin by safely lifting the vehicle and securing it on jack stands. Drain the transmission fluid by removing the drain plug or pan, then remove the transmission pan by unscrewing the bolts. Clean the mating surfaces, replace the old gasket with a new one, and reattach the pan with a proper torque on the bolts. Finally, refill the transmission with new fluid and check for leaks.
To change the transmission pan gasket on a 1991 Dodge Shadow, first, safely lift the vehicle and support it on jack stands. Drain the transmission fluid by removing the drain plug or loosening the transmission pan bolts, allowing the fluid to flow out. Remove the transmission pan by unbolting it, clean the mating surfaces, and install the new gasket. Reattach the pan, torque the bolts to the manufacturer’s specifications, and refill the transmission with the appropriate fluid.
To replace the transmission pan gasket on a GMC Savana 1500, start by safely lifting the vehicle and securing it on jack stands. Drain the transmission fluid by removing the transmission pan bolts, then gently pry the pan loose to avoid damaging it. Clean the mating surfaces thoroughly, install the new gasket, and reattach the pan with the appropriate torque specifications. Finally, refill the transmission with fluid as per the manufacturer's recommendations and check for leaks.
i need to know what the torque specs are on the rocker arms for a 97 Chevy lumina, 3.1L v6
On a 1998 Chevy Lumina with a 3.1L engine, the torque converter clutch solenoid is typically located on the transmission, specifically on the valve body. It can be accessed from underneath the vehicle, usually requiring the removal of the transmission pan for better access. The solenoid is usually mounted to the side of the valve body and connected by electrical wiring and fluid passages. Always consult a repair manual for specific details and diagrams for your vehicle.
You have to remove the transmission to replace the torque converter.You have to remove the transmission to replace the torque converter.