0
What else can I help you with?
What is the torque sequence for intake manifold on a 1997 mercury cougar 4.6liter?
The 1997 Mercury Cougar 4.6 liter engine intake manifold torque sequence should begin at each end of the manifold. Keep moving towards the center and alternating from and to end.
What are Torque specs for 1994 350 intake manifold?
Intake bolts should be torqued to 35 ft lbs in the appropriate sequence. There should be 12 total "intake" bolts
How do you replace the intake manifold gaskets on a 1998 Chevvy Blazer?
If you have to ask that question you probably should not attempt the job your self.
Where is the fuel injector on a 2000 blazer?
Under the intake manifold. Or should I say part of it. be very careful taking the unit apart .
1979 305 sbc stock what is the proper timing THKS?
PROPER TIMIMNG SHOULD BE LISTED ON THE INTAKE MANIFOLD PROPER TIMIMNG SHOULD BE LISTED ON THE INTAKE MANIFOLD PROPER TIMIMNG SHOULD BE LISTED ON THE INTAKE MANIFOLD
Where is 1985 blazer firing order diagram?
The firing order should be embosed on the intake manifold. On the top of it close to the front of the engine viewable just by looking at it from above.
Should transmission vacuum line come from carburetor or manifold?
from the intake manifold.
Where is the thermostat located on a 1997 Chevy Blazer?
located on the intake manifold just follow the upper radiator hose to the engine should be 2 bolts holding the thermostat housing down.
Where is the oxygen sensor on a 1996 Chevy Blazer?
should be on the exhaust manifold
Where is the exhaust gas recirculation valve EGR located on a 97 s10 Chevy blazer 43L AC v6?
It should be on the front of the intake manifold directly above and behind the water pump.
Where is the knock sensor on a 2002 Chevy Avalanche?
They (2ea.)are in the intake. The intake manifold will need to be removed to get to them. The wire harness and intake manifold gasket should both be replaced when reassembling.
What is the firing order for a 1996 Chevy Blazer S-10?
It depends on which engine. For the 4.3 V6 it is 6 1 2 3 4 5. The firing order should be stamped on the intake manifold.
