0
What else can I help you with?
Are torque lbs higher on rocker arms then head bolts for a Chevy Malibu?
No, head bolt torque is much higher than rocker arms.
How do you torque rocker arms on a 1997 4.0 jeep grand Laredo Cherokee?
To torque the rocker arms on a 1997 Jeep Grand Cherokee with a 4.0L engine, first ensure the engine is at top dead center on the compression stroke for cylinder 1. Use a torque wrench to tighten the rocker arm bolts to the specified torque, which is typically around 22 lb-ft. Follow the correct sequence for the rocker arms as outlined in the service manual, usually starting from the center and working outward to ensure even pressure. Finally, double-check the torque after completing the sequence to ensure all bolts are properly secured.
Torque specs Chevy 2.2l rocker arms?
what is the torque on 2.2 rocker arms and in what order
What is the torque spec for a 1995 Cadillac 4.9 liter rocker arms?
torque specs on the bolts that hold the rockers on a 4.9 cadillac motor
What is the intake manifold torque specs and ordering for the 3.4L on a 2001 Pontiac Grand Am?
need torque specs for 3.4 pontiac grand am intake and rocker arms
What is the torque specs for the rocker arms on a 2000 Chevy impala 3.4l?
The 2000 Chevy Impala 3.4 liter engine rocker arm bolt torque specification is 45 pounds. The rocker arm bolts should be torqued in 15 pound intervals.
What is the torque for the rocker arms on a 1998 Malibu And the torque on the intake bolts?
for the rocker arms bolts its-- 98 and later, step 1- 168 in-lbs. step 2-- rotate an additional 30-degrees. this is all for a 3.1 v6, the intake bolts are -- (lower) step 1, 62 in-lbs, step2, 115 in-lbs, intake manifold bolts/studs(upper)---18 ft-lbs,
Rocker arm torque specs?
what is torque spec for rocker arms on 2004 4.6 landrover discovery
What is the torque specs on rocker arms for 1997 grand am 3.1 engine they are bolt type not nuts Also must the engine be at top dead center to torque them?
According to alldata 13-15 ft lbs of torque are needed for the rocker arms. The engine does not need to be at TDC and it also does not have to be running.
What is the right torque for rocker arms 350 smb Chevy 1970?
Rocker arms are set to a specific preload or backlash on v8 Chevies. There is no torque specification.
What do you torque the rocker arms to when you reistall push-rods on 2003 3.4 Pontiac?
what should you torque the rocker arms to when you reinstall the push-rods to on a 3.4 pontiac
What is the torque spec for rocker arms on a 1998 Pontiac Grand Prix 3.1 L?
THe Chiltons says "14lbs + 30 degrees"
