The torque specification for the front drive axle nut on a 1994 Plymouth Acclaim is typically around 150 ft-lbs (203 Nm). It's important to ensure that the nut is properly torqued to maintain the integrity of the axle assembly. Always refer to the vehicle's service manual for the most accurate information and any specific procedures.
The front axle nut on a 1994 Plymouth Acclaim is 32mm OD. A 32mm axle nut socket should be available at most parts stores.
Unbolt and remove
The oil filter is on the lower front of the engine.
A 1990 Plymouth Voyager is a ( front wheel drive vehicle )
Under the car, just in front of the fuel tank.
All Neon's were front wheel drive. Whether it be the Dodge or Plymouth.
Check lower control arm bushings.
look at it and see.it will be obvious.,most have disc front and drum rear...if not all of them,,,
The fuel filter is on a front corner of the fuel tank.
If front axle of front-wheel drive, it's about 200 ft.-lbs. If back, not all-wheel drive, see question on rear axle of 92 voyager.
Yes
On the front of the Throttle Body, its held in by 2 Star Screws.