62 Lb-Ft
The drain plug for the engine oil on a duramax should be on the back of the oil pan at the very bottom.
To drain water from a Duramax diesel engine, locate the fuel filter water drain valve, typically found at the bottom of the fuel filter assembly. With the engine off, place a container underneath the valve, then open it to allow any accumulated water and fuel to drain out. After draining, close the valve securely and check the fuel system for any additional water contamination. Finally, ensure to replace the fuel filter if necessary and check for proper operation.
There isn't one. Pull the lower hose.
The engine oil drain plug torque spec is 19 Ft-lbs.
2006 honda odyssey engine oil drain plug torque
Empty your tank out, drain the fuel lines, as the gasoline will damage your diesel engine.
The engine would stop running. You would need to drain the gas tank. If the engine has been allowed to run since the diesel was added you would also need to drain the fuel line.
Some torque converters have a drain plug on them. Remove the rubber plug from the bottom of the bell housing. Crank engine a little at a time until the torque converter drain plug can be seen from the bottom. Unscrew the drain plug and drain the fluid. Put the plug back in.
You will destroy a diesel engine if you run gasoline in it. Do not even start the engine. You will have to drain the fuel tank, and all fuel lines.
Drain the tank, change the fuel filter, refill with diesel.
Depends on the year and engine which you fail to list.
If the van is a diesel, then you need to get the unleaded fuel out of the tank and drain all fuel lines and change the filter. This will damage your diesel engine. If you only put a small amount, such as a couple of gallons, then just drain the tank.If the van is a diesel, then you need to get the unleaded fuel out of the tank and drain all fuel lines and change the filter. This will damage your diesel engine. If you only put a small amount, such as a couple of gallons, then just drain the tank.