0
What is the torque specification for the head bolts when replacing a head gasket on a 1990 Nissan Pulsar vector SSS The engine type is N13?
The torque specifications are, for both the 1.8 litre 18LE and the 1.6 litre 16LE:
Stage one: 25Nm
Stage two: Tighten a further 60 degrees
Stage three: Tighten a further 60 degrees
Stage four: Tighten a further 60 degrees
Stage five: Tighten a further 30 degrees to 50 degrees, but do not exceed 135Nm
Perform the tightenings one stage at a time, performing the required action to all bolts before continuing to the next stage. Tighten them in this order:
10 6 2 3 7
9 5 1 4 8
Where '1' is the front of the car, and '7' and '8' correspond to the distributor.
Perform stages one through four, and then after finishing the rebuild and replacement, run the car to operating temperature. Then perform stage five at operating temperature.
What else can I help you with?
Does the 1990 Nissan Pulsar have a timing belt or chain?
The 1.6 litre four cylinder engine in a 1990 Nissan Pulsar NX has a timing CHAIN
Do you have to remove the trans when you replace an engine on a 1988 Nissan Pulsar?
no u do not
Does the 1989 Nissan Pulsar have a timing chain or a timing belt?
In a 1989 Nissan Pulsar NX : The 1.6 litre four cylinder engine has a timing CHAIN The 1.8 litre four cylinder engine has a timing BELT
What are the timing marks for a 1998 N15II 1.6L Pulsar engine?
nead reinstall chain timing of Nissan pulsar N 15
Check engine light stays on Nissan Pulsar n16 how to clear codes?
If the check engine light stays on for the Nissan Pulsar n16, you would need to check the engine in order to clear codes. You can take the car for service and the problem will be diagnosed and restored to normalcy.
Where is the starter on a 1987 Nissan Pulsar NX?
" The Pulsar starter is located centrally, underneath the engine close to the passenger compartment." According to my car, the E16i engine, it is on the drivers side of the engine below/behind the distributor.
Where can you get a engine wiring harness for a 1988 Nissan Pulsar NX?
The best place is to get it from a wrecking yard.
What is the engine timing for a 1989 Nissan Pulsar?
On a 1.6 litre, it's 7 degrees btdc.
Does the Nissan Pulsar have a cam belt or chain?
The 1983-89 Nissan Pulsar with the 1.5 1.6 & 1.8 engine have a cam belt. The belt must be replaced at 60,000 miles. Warning: All of these engines are Interference engines. If the belt breaks, serious engine damage will occur.
Does Nissan Pulsar 1997 have cambelt?
Yes, the 1997 Nissan Pulsar is equipped with a cambelt (timing belt) for its engine. It's important to check the specific engine variant, as maintenance schedules and replacement intervals can vary. Regular inspections and timely replacements are crucial to prevent engine damage due to belt failure.
What is the best engine oil for Nissan Pulsar 1993 SR20?
Magnetec 10w-40 should be the best oil
How many liters of engine oil Nissan Pulsar n15?
The Nissan Pulsar N15 typically requires about 4 to 4.5 liters of engine oil, depending on the specific engine variant and whether the oil filter is changed during the service. It's always best to consult the owner's manual or check with a dealership for the exact specifications for your specific model.
