0
When adjusting valve clearances on a 1997 Ford Festiva, inlet clearance is 0.20 mm/exhaust clearances are 0.30 mm. These specs are for models before 11/96 or try 0.50 after this date. Check your rocker cover for a sticker which denotes a newer engine. In that case be sure to check specs. In addition, if the Festiva has a 1.5 motor, the valves are hydraulic therefore need no adjusting. If they sound noisy, attempt a good cleaning with a market approved oil/kerosene but most likely they'll have to be replaced.
What else can I help you with?
How is a valve lash adjusted on a 1997 Cavalier?
reburton2@comcast.net You don't. Valve lifters are hydraulic, they automatically adjust for proper clearance.
How do you get the door trim off a 1997 Ford Festiva?
How do you get the door trim off a 1997 Ford Festiva?"
How do you adjust valve clearance on a 1997 Mazda B2600?
CONSIDERING THEY RUN HYDRAULIC LIFTERS... YES IT HARD.
How do you set timing for a 1997 Ford Festiva?
ford festiva stopped while driving it has fuel and power it just wont turn over
How do you adjust engine valve for a suzuki esteem 1997?
To adjust the engine valves on a 1997 Suzuki Esteem, first ensure the engine is cold and then remove the valve cover. Using a feeler gauge, measure the gap between the rocker arm and the valve stem. If adjustment is needed, loosen the lock nut on the rocker arm, turn the adjusting screw to achieve the specified clearance (usually around 0.006 inches for intake and 0.008 inches for exhaust), and then tighten the lock nut. Finally, recheck the clearance and replace the valve cover.
What Type of transmission fluid used in 97 festiva?
Ford did not make a festiva for sale in the us in 1997. They made and sold an Aspire auto trans or straight drive
What is the tappet clearance for Hyundai excel Gli 1997?
The tappet clearance for a 1997 Hyundai Excel GLi is typically set at 0.20 mm (0.008 inches) for both intake and exhaust valves when the engine is cold. It's important to check and adjust the clearance periodically to ensure optimal engine performance and prevent valve train noise. Always refer to the vehicle's service manual for the most accurate specifications and procedures.
Where is the jack located in your 1997 sable?
On a 1997 Mercury Sable : The jack is supposed to be with the spare tire in the trunk The spare tire is stored with the tire valve facing down and the jack is stored inside the tire rim
Where would you find the switch for the reversing light on a 1997 Ford Festiva?
Usually in or on the gearbox or transmission
When should the timing belt be replaced in a 1997 Ford Festiva?
I own a 1997 Ford Festiva Trio S 3-door wether it is a belt or chain is dependant upon the model but mine is a belt, and this is usually changed every 100,000 to 150,000 kilometers.
Where is egr valve located on dodge Dakota 1997?
A 1997 Dodge Dakota does not have an EGR Valve.
Does a 1997 venture have a heater valve?
Could you please tell me if a 1997 Chevy Venture has a heater control valve and if possible the location of the valve.
