Bolt pattern 5x114.3 or 5x4.5 Offset 40mm
4x114
The wheel bolt pattern for the 1993 Toyota Supra is 5 x 4.5 inches or 5 x 114.3 millimeters. The stud size is 12 x 1.5 and the offset is high positive.
No! a 1987 cutlass is rear wheel drive, the van is front wheel drive....wrong offset.
5 inch 4.25 108mm high positive offset
diagram of starter in a 1993 ford probe
5 x 5
No, a wheel from a 1993 Chevy is unlikely to fit a 1989 Jeep. The bolt pattern, offset, and center bore specifications typically differ between manufacturers and models. It's essential to check the specific measurements of both wheels to determine compatibility. Additionally, factors like tire size and intended use should also be considered when selecting wheels for a vehicle.
The measurements between the lugs on a 1993 Toyota Pickup 4x4 with a 6-lug wheel typically have a bolt pattern of 6x139.7 mm (also referred to as 6x5.5 inches). This means that the distance between the centers of two opposite lugs is 139.7 mm. Additionally, the lugs are usually spaced evenly in a circular pattern, with an offset that varies depending on the specific wheel design.
2 wheel low 4 wheel low Neutral 4 wheel high 2 wheel high
hi, i could'nt find the inertia switch on my ford probe 1994 for ages. Eventually I found it just above the wheel arch on passenger side in boot but you have to remove the plastic covering. Not easy to locate. Hope this helps.
its a Mazda engine . ( DOHC 4cyl. 16 valve 2.0l ) For the probe 1993
The transaxle is the transmission on a front wheel drive car . It's bolted to the rear of the engine ( in your case completely within the engine compartment )