What is trouble code P0016 2004 dodge stratus?

Answer 1

P0016 code means the cam and crank are not synchronized. Before trying to adjust the timing, check the cam position sensor. It's located on the front of the head. It's way easier to change that than timing the vehicle. Also, remember to reset the computer (disconnect the ground from the battery for 10 minutes or so) after doing this or the computer will still think there is a problem

Answer 2

P0016 - Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)

symptoms
The engine may turn over but not start up
The engine may rattle near the harmonic balancer which means that the tone ring is damaged
The engine may start up and run, but run rough

cause
Timing chain is stretched, or timing belt skipped a tooth because its worn
Timing belt/chain not aligned
Tone ring on the crankshaft slipped or broken
Tone ring on the camshaft slipped or broken
Faulty crank sensor
Faulty cam sensor
Bad wiring to crank or cam sensor
Timing belt or chain tensioner faulty

The fix
Check the cam and crank sensors and their wiring for damage. If you see broken/frayed wires, repair.
If you have a scope, check the cam and crank patterns. If a pattern is missing, suspect a bad sensor or a slipping tone ring.
Remove the cam gear and crankshaft balancer and tone rings for proper alignment, make sure they're not loose or broken and they haven't sheared the alignment key. If they are correctly installed, replace the sensor. If the signal looks normal, then check the timing chain/belt for proper alignment. If it's not aligned, check for a damaged tensioner.
Also check that the belt or chain isn't stretched. replace and recheck.