0
I had the same issue where the turn signals were not working, neither was the steering wheel controls (radio, cruise control, etc). I've just replaced the two fuses, 21 & 22, and now it works again. Even though the two fuses I replaced did not appear to be damaged.
AnswerI had the same problem. Though it did not appear to be damaged, I replaced fuse #22, which fixed the problem. Answerfunny that I ran across this question - just happened to me today. The fuse is not blown. I checked it personally and with a mech. Best thought on it so far is that the switch went out inside the turn signal lever itself.At this time I'm leaning towards this reason b/c my highbeams do not work either. I'm calling the shop tomorrow - I will have the definative answer in the next couple of days.
Removing the fuse resets the Steering Wheel Module, there is a down load to correct this condition.
What else can I help you with?
What is wrong when the brake lights and signals don't work?
Blown fuse
Chevy cavalier 1990 the turning signals dont work What can it be?
It COULD be a blown fuse. Check the fuse panel. It COULD by a blown flasher unit. If the fuse is OK, change the flasher.
What is wrong when a 1998 mercury mystique turn signals and blower fan won't work?
The fuse for the abs system is blown. Check under the driver side of dash for the fuse panel.
Hazard lights dont work on 96 integra?
Well if your turn signals still work its not a short. I just fixed a pinched wire on my 96 and now my turn signals dont work. But according to a buddy of mine on Clubintegra.com there is a chance the fuse for the hazards is blown.
What if you jump started your car wrong?
Replace blown fuse
Where is the fuse for the directional signals on 1989 Plymouth?
On a 1989 Plymouth, the fuse for the directional signals is typically located in the fuse box, which is usually found under the dashboard on the driver's side. You can identify the correct fuse by checking the diagram on the fuse box cover or the owner's manual, which will indicate the specific fuse for the turn signals. If the fuse is blown, it will need to be replaced to restore functionality to the directional signals.
Why do your turn signals and hazards not working?
fuse or blub is out or blown, or wiring is bad, or the relay is bad.
Why did the dash gauge illumination lights stop working in your 01 PT Cruiser after replacing the bulbs?
Bulbs mis-installed, blown fuse, connector not plugged in, wrong bulbs, etc.Bulbs mis-installed, blown fuse, connector not plugged in, wrong bulbs, etc.
What fuse controls the electric doors in the fuse box of a 106 mk1?
I assume its because the something to do with electric doors dont work? Look for the fuse that is blown. You can tell with out removing the fuse by the visible link at the top edge of the fuse. If no visible link then blown fuse.
What is wrong if radio seat belts dome light refuse to work?
Blown fuse.
Flashers work turn signals dont fuse is good on 1995 s10 blazer-what's wrong?
because there are two diffrent flashers 1 for the flashers and 1 for turn
What is wrong if your Ford Ranger turn signals and radio do not work?
Check your fuse!
