0
What else can I help you with?
Where is the purge solenoid on a gmc truck?
above the rear axle/driveline on the bed rail. there is a hose that goes to the canister to the left of it
What is GM rear end part number 3896839?
It is the stamped identification number on a 12 bolt rear housing for a Chevy/GMC vehicle that measures 60.625" axle tube end to axle tube end. Mostly truck housings but there are exceptions to this rule.
How do you change a rear axle seal on a 2003 gmc 2500 hd sierra?
Remove the tire and wheel from your 2003 GMC 2500 Sierra. Remove the end of the axle. Using a seal puller remove the axle seal. Reverse the process to install your new rear axle seal.
How do you replace shocks on a 1997 gmc pickup truck?
rear front or rear?
What type of rear differential gear oil is used in a 2006 gmc 5500?
What type of rear axle fluid is used in a 2006 GMC 5500
What could be the cause of a squeak in the rear axle of a 1997 GMC van?
a mouse!
How much can you tow with your 2011 gmc truck with a 3.42 rear end?
The towing capacity of a 2011 GMC truck with a 3.42 rear end varies based on the model and configuration. Generally, for most 2011 GMC Sierra models with this rear axle ratio, the maximum towing capacity ranges from approximately 5,500 to 10,700 pounds. It's essential to consult the owner's manual or the manufacturer's specifications for your specific model to determine the exact towing capacity.
How do you remove rear axle 1997 gmc yukon?
To remove the rear axle from a 1997 GMC Yukon, first, elevate the vehicle securely and remove the rear wheels. Next, disconnect the brake lines and the axle shafts by unbolting the differential cover and removing the axle retaining bolts. After that, support the rear differential and unbolt it from the suspension, then carefully lower it to remove the axle assembly. Be sure to consult a repair manual for specific torque specifications and procedures.
How much does a 1993 gmc single axle dump truck dump?
4289321 cubic inches
What brand of axles are in a 1980 gmc k20 truck?
Most likely its a Corporate 10 bolt front, and 14 bolt rear. Prior to 77 the front axle would have been a Dana 44.
How do you remove the rear axle on a 1988 Gmc vandura 2500?
To remove the rear axle on a 1988 GMC Vandura 2500, first ensure the vehicle is securely lifted and supported on jack stands. Disconnect the brake lines and any wiring connected to the axle, then remove the differential cover and drain the fluid. Next, unbolt the axle from the leaf springs, and finally, remove the axle shafts and differential assembly by unbolting them from the housing. Carefully slide the rear axle out of the vehicle.
How do you remove rear axle from 1993 GMC Sierra?
take off the drum stick a socket wrench through the hole in the axle and undue the four bolts then pull the axle out.
