answersLogoWhite

0

you use syncromesh pennsoil makes one you can get it at oreilly auto parts for 7.49 a quart

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What is the towing capacity for a 2002 Chevrolet tracker?

again the tow capacity for a 4x4 2002 Chevy tracker is 1500lbs but you should not tow anything without a transmission cooling system which you can purchase from your local uhaul company, if you tow with your tracker without the cooling system you will fry your transmission and damage your transfer case.


Is there a factory tow package for 2002 Chevy Tracker?

no there is not a factory tow package for the tracker, any tow package that you put on your tracker you will also have to install a transmission cooling system so you do not fry your transmission and damage your transfer case, you can get one at your local uhaul company.


Will a 2002 Chevy transfer case fit a 2003 Chevy?

YES, They are the same.


How do you tow a 2001 Chevy Tracker?

you need to refer to your manual on this one, if you were to tow a 4x4 Chevy tracker i know that you have to put the transfer case in neutral as well as the transmission, if you do not have 4x4 just your transmission should be in neutral....you should really refer to the manual im pulling this from some sort of memory.....


Can the front drive shaft on a 2002 Chevy Tahoe can be removed without fluids coming out of transfer case?

Yes it can.


Who carries a rightside tail light assembly for a 2003 Chevy Tracker?

You can try a junk yard or the Chevy parts house. It may be a special order part in which case it'll take a couple of days for the Chevy dealer to get it. Try a junk yard first, call before going on a treasure hunt.


Where is the neutral safety switch located on a 1998 Chevy Tracker?

On a 1998 Chevy Tracker, the neutral safety switch is typically located on the transmission, near the shift linkage. It's mounted on the transmission case and can be accessed from underneath the vehicle. This switch ensures that the engine can only start when the transmission is in either park or neutral. Always consult the vehicle's service manual for specific details and procedures.


What other Chevy cars parts are interchangeable with the Chevy prism?

The Chevy/Geo Prizm, was made by Toyota, I believe. All of the geo's were made by either Toyota, as GM were partners with them in the Roseville, California plant, I believe, or by Suzuki, which I know was the case with the Tracker, and the Metro. I think the Corolla, maybe the Toyota version, in which case everything is the same. Call your local Toyota dealer parts department. They will be able to tell you for sure.


Why is my 1996 Geo Tracker overdrive light flashing?

In almost every case of this occurrence, this is your tracker telling you it needs a transmission overhaul.


How do you make my 2000 Chevy Tracker 4x4 go it fwd?

To convert your 2000 Chevy Tracker 4x4 to front-wheel drive (FWD), you can start by disengaging the transfer case. This typically involves shifting the transfer case to the 2WD position, if equipped. However, it's important to note that this change is primarily a mode switch and doesn’t physically alter the drivetrain. For a complete conversion, you might need to remove or bypass the rear driveshaft and consider any modifications to the suspension or axles, which can be complex and may require professional assistance.


Will a transfer case from a 91 Chevy fit on a 2001 Chevy?

Will a transfer case from a 91 Chevy silverrodo fit a 2001 Chevy suburban?


Where is the crankshaft position sensor on a 2000 Chevrolet tracker?

on a 2002 Chevy tracker, it's behind the flywheel On my 2002 2.0 4X4 Tracker built 11/2001 the sensor is actually on the back of the overhead cam near the last fuel injector. Also the part that most stores provide is not correct for mine. There is no sensor behind my flywheel. Make if there is no wire going into the belhousing then you will not have one behind the flywheel as indicated by a previous answer. I'm not sure if any actually had it there. No mechanic I spoke to knew of one in that location. In my case change out is 5-10 minutes with one 10mm bolt. Mine did not have the 6" tail on it many show simply a right angle to the connector no wire pigtail whatsoever.