The 1998 Chevy Tahoe typically comes equipped with a front independent suspension and a rear solid axle. The front axle is a Dana 44 or a similar design, while the rear axle is usually a GM 10-bolt or a 14-bolt, depending on the specific model and configuration. The Tahoe can also come with either two-wheel drive (2WD) or four-wheel drive (4WD) options, affecting the axle setup.
The rear differential is where the driveshaft meets the axle. Its right in the middle of the axle and is about the size of a basketball.
The 1998 Chevrolet Tahoe typically comes equipped with a 10-bolt rear axle, which is part of the GM 10-bolt family. Depending on the specific model and options, it may feature either a standard open differential or a limited-slip differential. The axle is designed to handle the vehicle's towing and off-road capabilities. Always check the specific vehicle's specifications for any variations.
98 accord does not have a rear axle- just spindle/hub/bearing
how do you remove the right rear axle on a 1998 ford expedition?
Single piston, if it has disc brakes on the rear axle... some GM models still used drums for that MY. Not sure if the Tahoe did or not.
It is on top of the rear axle.
Pre 1998, it is on the back of the trans/transfer case After 1998, it is the rear axle abs sensor on top of the rear axle.
what is the torque 1998 beetle front spindle
It is on top of the rear axle.
Speed Sensor The sensor is located on the rear axle housing.
The axle ratio on a 1998 Mustang Cobra is 3.27:1