The speedometer signal comes from the abs computer via the rear axle speed sensor. That is the sensor on the top center of the rear axle.
The speedometer signal comes from the abs computer via the rear axle speed sensor. That is the sensor on the top center of the rear axle.
The speedometer sensor on a 2003 Chevy Tahoe Z71 is located in the engine compartment. It is on the transfer case.
The speedometer signal comes from the ABS sensors. There is one sensor on the top of the rear axle, and one at each front wheel bearing.
There are several things that can cause your 2003 Dodge Ram cruise control not to work. The most common cause is a blown fuse. A malfunctioning speed sensor can also cause the problem.
Output speed sensor
Dodge uses no such part.
It is in the top of the rear axle. The speedometer signal comes from the abs computer on the rear axle.
Where is the crank sensor on a 2003 dodge stratus 4 door 2.4 L DOHC?
No.
There definitely is a crank position sensor on a Neon
If the speedometer is not working but the odometer is, I would suspect the dash cluster is at fault. If both speedometer and odometer are not working I would suspect the speed sensor on the transmission is at fault.
Your speedometer, odometer, and cruise control quits working; That's all. It happened to me when I replaced the transmission on my Altima and the two wires came out of the connector.
These vehicles do not have speedometer cables. There is an Output Speed Sensor mounted on the transmission. That sends electronic data to the powertrain control module PCM and the body control module BCM. The PCM uses the speed data to coordinate shifting. The BCM uses the data to drive the speedometer. It's all digital. Rick I'm a retired ASE Master/L-1 Technician. I still keep current with the latest automotive technology. Visit my blog for cool articles and TSB's: http://free-auto-repair-advice.blogspot.com/ Follow the speedo cable inside eng compartment down to where it connects to the sensor. Unscrew the cable, pull the elec plug, take out the 10mm bolt, pull the sensor. Replace is opposite.