answersLogoWhite

0

1/2 or 13mm or 9/16 or 15mm I can not remember right now which. It will have three bolts that hold it on. That is for a Diesel starter.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What size bolts holds in a starter for an F250?

What size starter bolts for an 1993 Ford F250 4x4 automatic


Where is the starter and what does it look like on 2002 f250 ford diesel?

Where is the starter and what does it look like on 2002 f250 ford diesel?


How many mounting bolts are there on a 2004 ford F250 starter?

there are 3 mounting bolts on the starter motor.one is at the yop side of starter and you will need a socket with long extension to get at it PS : if you use a universal joint extension from socket set it will be even easier to get at


1989 ford f250 fuel problems it cranks but won't start?

1989 ford F250 Fuel Problems, It cranks but wont start


Where is the starter located on a 1989 Ford Bronco and how do you replace it?

its located where the tranny bolts up to the motor. disconnect the three wires from the starter, then take the three bolts out of the starter and pull it out. just remember where the wires go!!


How do you change a distributor on a 1989 Ford F-250?

how do you change out the distributor assembly on a 1989 ford f250


What is the oil capacity of 1989 Ford F250 diesel?

10qts


How do you install the starter solenoid of a 1988 Ford Bronco ii?

Where can I find a free starter solenoid replacement diagram for 1988 ford f250


How do you replace starter on a full size 1989 Ford Bronco?

remove batt. cable from starter(its not wired to batt so has no power) remove 2 1/2 bolts remove starter


How bolts hold the starter in place in a Ford Expedition 2001?

4 bolts


How do you replace the starter on an F250 5.4 liter?

To replace the starter on a Ford F250 with a 5.4-liter engine, first disconnect the negative battery cable to prevent electrical shorts. Then, locate the starter, which is typically found on the passenger side of the engine near the transmission. Remove the mounting bolts and electrical connections from the old starter, then install the new starter by reversing the process, ensuring all connections are secure. Finally, reconnect the battery and test the starter to ensure proper function.


How many bolts to the starter for Ford 1989 Crown Victoria 5.0 Ltr?

Usually only 2 to block & perhaps 1 for brace-if applicable.