7mm Hex.
7mm
7mm hex socket
the brake sensor for the 2001 dodge stratus is located on the inside of the car under the brake paddle.
a brake caliper tool (really)
Lift the car, remove the tires, remove the brake shoe/calipers, and remove the old brake pad. Put in the new brake pads, replace the brake shoe/caliper, replace the tire and lower the car.
You put brake fluid in the brake fluid reservoir on a 1998 Dodge Stratus. This is located on the master cylinder, under the hood, on the driver's side.
== ==
To remove the rear brake calipers on a 2009 Dodge Journey, start by safely lifting the vehicle and removing the rear wheels. Next, locate the caliper mounting bolts on the back of the caliper and use a socket wrench to remove them. Carefully slide the caliper off the brake rotor, supporting it to avoid putting stress on the brake line. Finally, secure the caliper with a bungee cord or similar to prevent it from hanging by the brake line while you work.
Find diagram of 1999 a Dodge Stratus DOHC engine
First use large screwdriver to fit between caliper and pad to force piston back, now remove caliper, take out old pads, fit new ones in same place, tighten caliper.
Yes
two bolts in the steering knuckle and the brake line are all that attach to the brake caliper