0
What else can I help you with?
Where should the needle on the temperature gauge be when driving a 1988 jeep grand wagoneer?
that depends on the thermostat. but the book calls for 190 degrees. your gage should be + or - 10
Where is the Temperature sending unit located on a 1988 Chevy 305?
connected to thermostat housing
Will a 1986 Ford Taurus transmission fit in a 1988 Ford Taurus?
yes only of they have the same engines. there should be no problems.
How hot should a 1988 Jeep Wrangler run?
Depends on the thermostat temperature rating. Stock will be 180-200˚. You should only, repeat only (!) see 200˚ when 4-wheeling at slow speeds.
Where is the location of coolant temperature sensor 1988 Jeep wagoneer limited?
what engine do you have? if it is a 360 it is located on the thermostat housing.
Why doesnt your temperature gauge work in a 1988 ford thunderbird work?
More then likely you need to replace the Thermostat.
Where is the cooling fan relay located on a 1988 Ford Taurus?
The 1988 Ford Taurus cooling fan relay switch can be found on the front drivers side quarter panel. The fan relay switch should be labeled as such.
What parts are needed to tune up a 1988 Ford Taurus?
What are the parts for a standard tune up for a 1988 Ford Taurus?
Where is the temperature sensor on a 1988 Mazda B2200 pick-up truck?
It is located under the thermostat housing with a single wire connection.And the upper radiator hose goes to the thermostat housing.
Where is the coolant temperature sensor tw located on a 1988 Honda Accord 4-cylinder fuel injected with a manual trans located?
The 1988 Honda Accord coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.
How do you replace a thermostat on a 1988 Pontiac Bonneville?
The thermostat is on the top of the motor where the top radiator hose attaches to it. The housing for it should be held on with two bolts. Remove the bolts and lift up the cover. There's the thermostat.
What the normal operating temperature of a 1988 Mercury 454 330 hp Bravo One marine engine?
The best operating temperature for this engine is between 150-160 F. It should not be running at the same as your car which is a higher F. temp. You should have a 160 F. thermostat which will open at or be fully open at 160 F.
