0
What else can I help you with?
How do you reinstall a belt tensioner for a 87 Ford Taurus?
To re-install a belt tensioner for a 1987 Ford Taurus, tighten the bolt when the tensioner pulley is holding the serpentine belt tight. The belt tensioner sits in a slot and can be adjusted to hold the belt tight.
How do you tighten an alternator belt on a 95 Ford Taurus?
You have to install a new belt tensioner.
Is the timing belt on a 1999 Ford Taurus 0 tolerance?
Only the 1999 Ford Taurus SHO has a timing belt. The engine is built by Yamaha and NO it is not an interference engine. Replace the belt at 100,000 miles. All other Ford Taurus's have timing chains.
Will a broken timing belt on a 99 Ford Taurus damage the engine?
The 1999 Ford Taurus does not have a timing belt. It has a chain that requires no maintenance.
How do you tighten the fan belt on a 1998 Ford Taurus SE wagon?
It uses a spring loaded belt tensioner. The tensioner is autmatically set. IF there is not enough tension, then replace the tensioner. The belt may be stretched and need replacment however.
Serpentine belt keeps breaking on ford Taurus 2003?
Something is out of line. Check alternator, a/c pump, idler and tensioner. I've had 3 Taurus and never a single broken belt.
Where would the belt tensioner be located on a 1998 Ford Taurus when replacing the serpentine belt?
As viewing the motor from the front of the car, the belt tensioner is located on the left side of the engine. On what is essentially the front of the motor, the belt tensioner is located just below the idler pulley.
When should the timing belt be changed for a 1999 Ford Taurus?
You do not need to replace the timing chain because there is no timing belt at all on Ford Taurus. It has a timing chain.
How do you tighten the belt tensioner on a 93 Taurus?
The tensioner has a spring in it that provides the correct tension for the belt. If it is too loose, replace the tensioner.
What belt tensioner tool is needed for 1999 Ford E-350 Van with V6?
you do not need a tool to tension pully belt if belt is loose, belt needs replacing tensioner works automatically
My 1999 Ford Taurus serpantine belt keeps shredding I have had the pulley's replaced the belt tensioner replaced the bearings The belt keeps shifting over then shredding Any ideas?
had a freind his truck did the same thing and come to find out they gave him a wrong part. i cant remember if it was suppose to be a four groove and the gave him a five belt. or it was a tensioner he had to switch the pulley off the old to the new
Diagram for a belt on a 2005 Ford Taurus?
2005 ford taurus serpentine belt diagram
