0
You don't. The security system is built into a couple of the computerized modules including the PCM. Basically the comuter needs to see the chip in the key or it will not start.
Please note that you can bypass the security system by installing an equivalent resister across the two wires that go to the ignition cylinder. You will need to cut the wires so that the computer doesn't 'see' the chip and the bypass resistor. The resisters go on the side that does not go up to the lock, it goes acorss the wires that go down to the connector which leads back to the pcm.
What else can I help you with?
Clear fault codes 2000 Buick park avenue?
The steering colums was changed on my 2000 buick park avenue and it still wont start. do I need to get the security light to go off first
What to do to get the security light off the 1993 buick park avenue?
turn ignition on leave it on for 10 minutes then switch ignition off then you start the car
1993 Buick park avenue will not start?
my 1993 buick park avenue wont start after i changed the front motor support you can jump it from the sodinoid and it will crank whats wrong could it be the security system
When Did The Buick Park Avenue Start?
The Buick Park Avenue Started In 1991
How do you bypass the pass key II system on a 93 Buick lesabre security light flashes no crank no start?
how do i bypass the security code on my 1995 buick lasabre because my key is bad and i dont want to pay 185.00 for a key
How do I fix the problem of the security dash lamp staying on in my 1992 Buick Riviera?
I'm looking for help.The secority light is on car won't start.
My 1989 buick lesabre want start what's wrong with my car?
give symptoms: any noises (if so describe), is security light on dash on, etc.
How do you remove the door speaker in a 1993 buick park avenue?
start by taking the door panel off ....
What would cause a 1991 Buick Park Avenue not to start when the engine is cold?
check crank sensor
Buick park avenue starts when it wants to?
Electrical problem, check batt cable connections to start
What does pk3 mean in your 2000 Buick park avenue key?
In the context of your 2000 Buick Park Avenue key, "PK3" refers to a type of anti-theft system known as the Passkey III. This system uses a transponder chip embedded in the key, which communicates with the vehicle's ignition to ensure that only the correct key can start the engine. If a non-compatible key is used, the vehicle's security system will prevent it from starting, enhancing overall security against theft.
1992 Buick Park Ave with the pass key security system It will not start Security light keeps coming on Is it the passkey device in the ignition?
AnswerYes...wait at least 3 mins before trying to start the car again when this happens.....because the car WONT start for at least 3mins when the passkey system is activated...security light keeps flahing when turn keyon ... won let car start
