0
What to they mean when they need to get something pressed out when working on the left rear axel seal on a 1989 F150?
Your truck uses bearings that are pressed onto the axles IN FRONT of the seals. GREAT design i know. The Bearigns have to be presses off and usually replaced when changing axle seals. Usually the cause of the axle seal leak IS a worn Bearing, causing the axle to move too much, and out of the seals range on motion.
What else can I help you with?
1989 Ford F150 and the heater isn't working It only blows cold air What could be the problem?
The thermostat may be stuck open.
Why are my Tires tipped in on 1989 ford f150?
Front springs are sagged out, camber is out(kits for upper ball joints available) or something is worn out or bent.
What is the Curb weight of a 1989 Ford F150?
approximately 4013 lbs.
Why won't my 1989 F150 start?
One reason a 1989 F-150 may not start is a bad battery.
What is the spark plug gap for a 1989 F150 with a 300 engine?
www.motorcraft.com shows (.044 inch ) plug gap on the 1989 F150 300 cubic inch ( 4.9 L ) straight 6 cylinder engine
Need Radio wiring diagram 1989 Ford Pickup F150?
Yes.
Where is cylinder 1 on 1989 ford f150 5.8L?
front passenger site
Can a 1989 bronco 302 engine swap into a 1995 F150 302?
sure can!
Where is your knock sensor on a 1989 4.9L F150?
to the rite and just below the coil
What would cause the headlights to stop working on a Ford F150?
The headlights in the Ford F150 may have stopped working due to a bad fuse or bulb. Check these and if it doesn't fix the problem visit a mechanic.
What other ford gas tank will fit a1965 ranchero?
1989 Frod F150
Does a 1989 f150 have an obdII port?
No , there is probably an EEC TEST connection in your engine compartment
