0
I am assuming you are refering to the brake rotor. A basic metric socket or wrench set. a pair of needle nose pliers. a small flathead screwdriver and hammer.
start by doing the obvious. jackstands and wheel chocks.
remove the wheel
unbolt the caliper and hang it out of the way with wire/zip ties ect..
unbolt the caliper mounting bracket
remove the dust cap from the face of the rotor
remove the cotter pin
unscrew the castle nut
pull the rotor off
What else can I help you with?
Time needed to change cap and rotor on1993 corvette?
about 30 min if you have tools available
Are special tools needed to rebuild a ranger 4r44e transmission?
Yes they are you need a few tools not to hard to get they will cost about 100-300$
How do you change the rotor on a 1996 Accent without removing the hub the rotor is bolted on to the back of the hub which is pressed on This is a right hand drive car?
the hub must be removed to take off the rotor.special tools are required to remove the rotor.
What tools are needed to take off brake rotor?
first take off the wheel then look at the caliper bolts they can range from metric sockets to torx sockets remove the caliper secure the caliper so that it does not hang from the brake hose then inspect the caliper support bracket bolts remove the two bolts being careful not to get hurt when it falls to the ground using some penetrating fluid and a hammer tap the rotor from the backside tap the rotor off of the hub
Are there any special tools needed to remove the front rotors on a 1991 town car?
No, normal mechanics tools.
What tools are needed to remove tile effectively?
To remove tile effectively, you will need a few tools including a hammer, chisel, pry bar, and a scraper. These tools will help you break and remove the tiles without damaging the underlying surface.
What tools are needed to remove install a water pump on a 1995 Pontiac Grand Am v6?
Normal metric mechanics tools. No special tools are needed other than what any mechanic would own.
Tools needed for removel for 2005 tahoe front bumper?
Tools needed to remove the 2005 Tahoe front bumper are 10 mm and 7 mm panel poppers.
What tools are needed to remove tile from a concrete floor?
To remove tile from a concrete floor, you will need a few tools including a hammer, chisel, pry bar, and a floor scraper. These tools will help you break and remove the tiles and adhesive from the concrete surface.
What tool is needed to remove a front hub from a 2003 Frontier?
There are two tools needed to remove a front hub from a 2003 Frontier. These include a screwdriver and a cone wrench.Ê
What tools are needed to remove a tile floor?
To remove a tile floor, you will need the following tools: a hammer, a chisel, a pry bar, safety goggles, gloves, and a dust mask.
What tools are needed for oil change?
The tools needed for an oil change tend to be common tools. A floor jack is needed to access the oil pan. A pan which is used to drain oil into. A wrench and socket set is used to remove and replace the oil cap.
