0
This will refer to the front drivers and passenger doors only. I havent tried the others yet. You will need a PHILLIPS SCREWDRIVER only. No other tools are necessary. After you remove the 2 screws in the arm rest and the 2 screws behind the door handle and you remove the trim piece forward of the window, the panel is just held on at this point by hanger hooks. Simply struggle with lifting the entire door trim panel straight up to release these hooks. Caution is needed here to prevent breaking these hooks. Another caution here.......when you get the panel released, do not lower the panel towards the ground. You must disconnect the short wiring harnesses off the power window switch and the power door lock switch. They are not very long.
What else can I help you with?
How do you remove the door panels to a 1990 Honda civic?
with hand and tools...
How do you remove the radiator in a 2006 Chevy Cobalt?
with the correct tools
How do you remove the transmission on a 1989 Chevy Caprice Classic Brougham?
with tools
How do you remove 2005 Chevy Avalanche rear bumper?
With a few simple inexpensive tools.
How do you remove hayabusa panels?
To remove the panels on a Hayabusa motorcycle, locate the mounting bolts that hold the panels in place and use the appropriate tools to unscrew them. Gently pull the panel away from the bike to release it from the mounting points. Be careful not to force the panel or damage any clips or tabs that secure it.
What size metric or standard tools are needed to remove a water pump in a 1998 Chevy S10?
well get out your tools and keep trying sizes until on works
How hard is it to remove a 1992 Chevy s10 5 speed transmission?
If you have the right tools and a transmission jack, it's quite easy.
How hard is to remove a 1992 Chevy s10 5 speed transmission?
If you have the right tools and a transmission jack, it's quite easy.
How is the dashboard removed from a 1995 Chevy Monte Carlo Z34?
1995 Chevy Monte Carlo has front air bags and has special tools to remove them. It is about a 7 hour job to remove a dash from this vehicle but if you insist on doing this start with dropping the steering column.
How do you replace a ignition key lock cylinder on a 90 Chevy pickup with tilt wheel?
Remove the steering wheel, Then remove the turn signals section. This takes some special tools.
How do you change backing plates on a Chevy Trailblazer?
You must remove the axle to replace the backing plates. It is job for the professional do-it-yourselfers with all the tools.
How do you change a pitman arm on a Chevy truck What special tools is made to remove the pitman arm without taking off the power steering pummp?
Bring it to the garage. it is a pain. you have to remove the power steering pump
