Most likely, the gas port is dirty and not enough gas is getting through to cycle the action. It could be that the chamber is dirty of corroded and not releasing the hull or the extractor could be damaged and not pulling the hull out. Clean the gun well and inspect the extractor.
Weak spring, bad magazine, dirt, etc..
When a shotgun is fired, the trigger is pulled, causing the firing pin to strike the primer on the shotgun shell. This ignites the gunpowder in the shell, creating a rapid expansion of gases that propel the shot or slug out of the barrel. The blast of the gases also causes the action to cycle, ejecting the spent shell casing and chambering a new shell if the shotgun is semi-automatic or pump-action.
Shell-ejecting airsoft guns tend to eject their shells using a spring loaded system. once the bolt, or slide is drawn back after firing, the spring will force the spent shell out of the gun
To cock an AK47 means to pull the handle back which sets the firing pin, so that when you pull the trigger the firing pin goes forward and detonates the primer thus firing a shot. The AK47 being a semiautomatic weapon ejects the fired (spent) shell, as the slide goes back to eject the shell sets the firing pin for the next round.
No, spent shell casings are not allowed on a plane due to security regulations.
Your rifle was manufactured by Winchester as their model 121. The spent shell is removed from the chamber by action of the right and left extractors and is then bounced out by bumping agains the ejector. Look for problems there. Parts are available from gunpartscorp.com.
Yes
About 157 mins spent in action... not including time outs and inning switches
To collect your spent shell casings.
I have the same question. Did you find an answer?
I'm not certain what you mean, "how do you use a boltaction", but I'll go with it anyway. Bolt action, simply refers to the mechanism that ejects the old shell and loads a new shell into the chamber. The bolt action is a kind of handle on top of the gun, and when you want to load a shell, and this is assuming it has the capacity for more than one shell, you raise the handle up, and pull it back;this will eject a spent shell if you've already fired it; then push the bolt forward, which loads a new shell. If it's a single shell capacity, or single shot, you'll have to follow the above instructions, but load the shell in manually after you've opened the chamber by pulling back the bolt. Clear as mud.
A bolt is one of the main components of a firearm - it's a part in loading the cartridge, firing (in conjunction with a firing pin), and ejecting the spent cartridge.