answersLogoWhite

0

If you are talking about the coolant cross-over, on the intake, then the new modified one has to be installed. cost around $ 250.00 for the part, and 6 to 8 hours labor.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Does a 1987 mercury marquis have a ho intake manifold?

No, not as standard.


What would cause antifreeze to be where your spark plugs are in a 1997 Mercury Grand Marquis?

Intake manifold gaskets are leaking, intake manifold is warped.


Where is the intake plenum on 1999 mercury villager?

The intake plenum is simply the top of the upper intake manifold, where the throttle body is attached. It is made of black plastic.


How much to replace a intake manifold on a grand marquis?

alot


What are the intake manifold torque specs on a 2000 mercury grand marquis intake bolts?

The torque specification for the intake manifold bolts on a 2000 Mercury Grand Marquis is typically around 11-15 ft-lbs (15-20 Nm). It's important to follow a specific tightening sequence, usually starting from the center and working outward, to ensure even pressure. Always refer to a repair manual for your specific vehicle for the most accurate information.


Do you have to remove the intake manifold to change the bypass hose on a 1997 4.6 Mercury Marquis?

No, not for the hose but, I have seen the metal bypass tube that the hose connects to, rust out and cause a coolant leak out the back of the engine. The intake manifold would have to be removed to replace that metal tube.


Intake Manifold - Cross-Over Channel Coolant Seepage on mercury grand marquis 1998?

There is really no safe way to repair this. You have to change the intake. This is about a 6 to 8 hour job. The oem intake has a defect. At this point Ford will not do anything for you. The old intake has a plastic cross over, which after time will crack. The new intake has been modified. Check around the net, you can find one for around 200. $


How do you replace the intake manifold 1997 mercury grand marqie?

To replace the intake manifold on a 1997 Mercury Grand Marquis, first, disconnect the battery and remove any components obstructing access, such as the air intake and throttle body. Then, drain the coolant and remove the intake manifold bolts using a socket wrench, carefully lifting the manifold off the engine. Clean the mating surfaces, apply a new gasket, and install the new manifold by reversing the removal process, ensuring all connections are secure and the system is properly refilled with coolant before starting the engine.


How do you replace a water pump and intake manifold on a 1997 Mercury Grand Marquis?

For the manifold see link below for detailed info on the class action settlement and detailed DIY instructions... http://www.autoclinix.com/Manifold.htm Is the intake cracked? Is it a 4.6L? If so, a recent class action settlement extends the warranty, on the intake, to 70,000 miles. Don't replace with OEM manifold.


Where is the manifold in a 1995 Cadillac ElDorado?

The intake manifold is underneath the plastic silver cover held down by four nuts. Take it off and you'll find the intake manifold - also plastic. Even more unusual, the starter is underneath the intake manifold!


Does a 1990 grand marquis with a 5.0L engine have a PCV valve?

YES , a 1990 Mercury Grand Marquis 5.0 liter V8 engine has a PCV valve ( Motorcraft part number EV-98-B ) going into the intake manifold


Where is the Mass air flow sensor on a 1987 Mercury Grand Marquis?

mass air flow sensors are generally located in the air passage between the air filter and the intake manifold.