answersLogoWhite

0

the hot wire goes to the starter and the ground wire bolts to the engine block.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

My Windshield wiper motor stop working for my 1995 cutlass supreme. Can you tell me which wire is the hot wire and the ground wire?

Red is hot, black is not.


Antanna wiring diagram for 1993 Oldsmobile cutlass supreme?

show wire names for car stereo


Some one help find the ignition wire diagram for a 1985 cutlass supreme 2 door thanks a lots?

The ignition wire diagram for a 1985 Cutlass Supreme 2-door, can be found in a Chilton's Automotive Repair Manual. This manual can be purchased at many automotive parts stores, or found in some libraries.


Where is the starter located in a 1990 Oldsmobile cutlass supreme?

If the vehicle is a Front Wheel Drive vehicle, the starter will be located in the front lower part of the engine. Just look for a large black wire that is attached to the motor and just follow the wire and it will lead you directly to the starter motor. Good Luck.


Does a 1990 corvette has a 2 wire IAT sensor?

The 1990 Chevrolet Corvette IAT sensor does have two wires. The sensor has a ground wire and a positive wire.


How do I disable horn in 1989 Olds mobile cutlass Supreme?

you can pull the fuse in the fusebox that controls it or you can find the horn and pull the wire off of it.


How do you wire the speedometer on a 1987 Olds Cutlass Supreme?

Under neath the speaker insulation, behind the dash board. left of the glove compartment.


Why is my ground wire melting on my 1990 f-150 when i try to start the vehicle?

The ground wire is melting on the 1990 F150 when trying to start the vehicle because the wrong wire is being used as a ground wire. The wires are color coded. Perhaps the factory made a mistake with how the wires were hooked up.


1990 cutlass left brake light fails to come on does slightly blink in sync with right brake light when rear park running lights are on in order to see the left brake light blink slightly?

its a ground wire


Where's the blower motor for a 1986 olds cutlass supreme?

It is in the top left section of the hood. the top left if you are facing the grille of the car. it has a hose connected to it and it has to have a ground to it. on my car it didnt have a ground so it was not working i had to get a new blower motor but it has to have a ground. i used a screw and wrapped a wire around it. it does not blow very hard. hope this helps.


What is the wire diagram for a 1990 olds cutlass supreme?

The wiring diagram for a 1990 Oldsmobile Cutlass Supreme can vary based on the specific electrical system and options installed in the vehicle, such as the engine type and whether it has features like power windows or locks. Generally, you can find detailed wiring diagrams in the vehicle's service manual or repair guides, which outline the connections for the ignition system, lighting, and other electrical components. For precise information, it's recommended to refer to factory service documentation or specialized automotive repair websites.


How do you open the hood on a 1995 Cutlass Supreme if the hood release wire is not working from within the car and you can see the hood latch under the hood but you can't get the hood up when you try?

This is what I have had to do for my 94 cutlass supreme. Hold the hood release wire lever open from inside the car with a something - a screwdriver or some such thing. Then just pull up on the hood and voila, it releases the latch.