answersLogoWhite

0

I would suspect a worn drive belt. Inspect all belts.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What would cause the overdrive off light to flash on a 2000 ford ranger?

A malfunction has been detected - get it checked out


How do you reset the chirp on a 2000 Toyota Sienna when you lock it with the remote?

i dont think you have chirp only lights will flush


How do you bypass anti-theft system on Ford Ranger?

How do you bypass the alarm on a 2000 Ford ranger cause I replaced the ignition


How do I fix a 2000 Ford Ranger code of PO304?

Code P0304 on 2000 Ford Ranger is: Misfire at cylinder 4 detected. May be cause by a bad spark plug.


What would cause check engine light to stay on in a 2000 ford ranger?

You would really need to have your Ranger scanned for any trouble codes to diagnose and then repair the malfunction with your emission control system . There are just too many possibilities


What would cause the RPMs to increase when the clutch is in on a 2000 ranger 4-cylinder?

I read another fellows comments about his Ranger RPM going to 2000 to 2200 RPM whenever he shifted gears on his 5 speed manual transmission and he said that it turned out to be his throttle position sensor


Can you use a transmission from a 1993 Ford Ranger to a 2000 ranger?

can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?


How much oil should you use in a 2000 Ford Ranger?

That would depend on what engine size you have in the 2000 Ford Ranger ( also , do you want the answer in U.S. quarts or using the metric system / in litres )


Where is the fusible link on a 2000 Ford Ranger?

where are the fuseible links located on a 2000 ford ranger


What would cause the tachometer temperature gauge and fuel gauge not to work on a 2000 Ford Ranger XLT Fuse is good?

I had a 2wd 2000 ranger xlt and this happened to me. The part that I replaced is called a "speed sensor". It in an inexpensive and easy part to change out yourself. It is located on top of your rear end under the bed. A simple wrench will do the trick.


What are the bolt patterns for a 2000 Ford Ranger?

bolt pattern for 2000 ford ranger & ft pounds


How do you install a rear window on a 2000 Ford Ranger?

How do you install a rear sliding window on a 2000 Ford Ranger?