0
HI, Have you looked at your EGR valve? our air cleaner could be real dirty, the mass airflow sensor could be bad, Ther's any number of things that could be bad or wrong. Have you had your codes read? The reasdout from the OBD can lead you in the right direction. The problem I found is that it raeds from the last component failure or problem and it stores fropm the most significat problem first so you get one thing done then you go to the net. I have a '97 2dr auto 4wd abd I've gone through many things and I'm still not done. I'm glad we're all here to help each other. Good luck and keep asking if thyou find out. Steve H.
What else can I help you with?
2002 F350 7.3 liter diesel power cuts out when driving?
Camshaft position sensor. There is a recall for them i believe. It will cause cutting out and stalling. It happened to ours too. Camshaft position sensor. There is a recall for them i believe. It will cause cutting out and stalling. It happened to ours too.
Can a faulty MAP sensor cause stalling?
The MAP sensor - another frequent cause of stalling or non-starting. This measures the air pressure in the manifold. You can test it - if your car won't start, just unplug the electrical connection from the MAP sensor. If it starts, replace the sensor. MAP sensor details. (It may act as though the fuel pump is not working properly - starting, then quickly dying).
Will a faulty fuel rail pressure sensor regulater cause stalling?
A fuel rail pressure regulator could cause trouble.
Would a bad speed sensor cause a no start and stalling?
Yes, a bad speed sensor can cause a no-start condition and stalling, particularly if the vehicle relies on the sensor for critical engine management functions. The speed sensor provides information about the vehicle's speed to the engine control unit (ECU), which may affect fuel delivery and ignition timing. If the sensor fails, the ECU may not receive the necessary data to operate the engine properly, leading to stalling or preventing the engine from starting altogether.
Would a bad camshaft position sensor cause stalling and hesitation?
yes definitely my 96 Chevy was stalling every time i stopped at a light or stop sign and my brother changed my crank shaft sensor and it doesn't do it anymore.
Would a dirty air filter cause stalling?
It can if its dirty enough. Spend ten bucks and replace it to see if your stalling goes away. Replaced mine today and its purrin.
Whats cause of intermit stalling and diffulcity starting on 94 wrangler 4 cyl manual. stalls no warning lights in message center fuel pump does not acuate. replaced crank censor and ingnition switch?
If your 1994 Jeep Wrangler is stalling and having difficulty starting, there could be an issue with the throttle position sensor. A damaged TPS can also cause hesitation when accelerating.
Can a Faulty Camshaft sensor on a 3.5L Chrysler 300M cause my stalling problem when the engine is hot?
Yes, that is one of many possibilities.
What is the cause of stalling immediately after starting for a Volvo 240DL?
Souds like vaccum leak, anywhere between MAF sensor and intake manifold.
Can a bad oxygen sensor cause a stalling problem in a jeep 4.0?
Yes it can. If the oxigen sensor is bad, the computer keeps getting signals of deficient combustion and will try to vary the amout of fuel going into de injectos. This can cause the car to stall.
What would cause a car to jerk during acceleration and stall out after you've replaced the muffler temperature coolant sensor and fuel filter?
check plugs and wires, and the fuel filter for proper installation. Fuel filters have a directional arrow on them, to indicate which way to install them. If it is in backwards, that can cause fuel starvation and stalling under load, such as when you are accelerating.
What could cause low idle speed or stalling at idle when in gear auto tranny in a 96 320?
Check your IAC it may need to be replaced/cleaned
