0
What would cause a Mazda B3000 to not start after it has been sitting The engine will turn over fine but it will not fire?
I have a 1994 B3000 that started doing that several years back. It was a relay that was located within a black box on the drivers side of the engine (I believe there are 3 relays in the box). I found that one of the relays was sticking. When lightly 'tapped' on it would release and the engine would start. After replacing it, the problem went away. Note Did they have the "Fuel Cutoff Switch" in those years of pickups? Typically, it's designed to remove power from the fuel system in the case of an imact or jarring. Check to see if it was somehow popped, and just push the button back in if you have one. Should be under the dash, right above or at the top of the carpet/floor mat passenger side. Little box with a single plug and a red button at the top typically. It may also be the ignition module. I had the same problem with my '94 B-3000. If it sometimes dies on you while driving it probably is the same thing. After replacing it the problem went away.The module is easy to replace. It is located on tn the front of the vehicle , drivers' side next to the radiator. Also tapping it several times may get you by until it can be replaced.
good Luck.
What else can I help you with?
What would cause a 1998 Mazda B3000 to not start after it has been sitting The engine will turn over fine but it will not fire?
Spark plugs not producing enough spark. Battery doesn't have enough charge. Old fuel.
Why does the 4wd not work on a 99 Mazda b3000?
cause you farted on it
Would a bad clutch fan on a 1994 Mazda B3000 cause it to overheat?
Yes it could.
What would cause a 2002 Mazda B3000 to overheat for 10 seconds and then return to normal?
Bad thermostat
How can you detect the cause of a shake in a 1992 Mazda 929 engine when the car is sitting at a red light?
TAke it to a garage as it could be several things and to guess is wasting money.
What could cause my 1994 Mazda B3000 truck to tremor and shake when I start it up and have a hard time accelerating when driving?
It could be a stuffed catalytic converter.
Is it possible an electrical problem on a Mazda 323 can cause the engine coil to burn?
Is it possible an electrical problem can cause my engine coil to burn on my Mazda 323
What would cause a knock where the motor and trasmission meet 1995 Mazda b3000 5 speed?
cracked or warped flywheel Spring on the pressure plate could have come loose.
How do you fix a noisy lifter in 2000 B3000?
To fix a noisy lifter in a 2000 Mazda B3000, start by checking and changing the engine oil and filter, as low or dirty oil can cause lifter noise. If the noise persists, consider using an oil additive designed to clean and lubricate lifters. If the issue continues, you may need to inspect the lifters for wear or damage, which could require disassembling the engine to replace them. Always consult a repair manual or a professional mechanic for specific guidance tailored to your vehicle.
What can cause a 1994 Mazda MX-6 not to heat up after the engine is warm?
catalytic converter
Is Mazda 2.5 L v6 an interference engine?
A Mazda 2.5 L V6 is an interference engine which has very tight tolerances. A slight misalignment of the timing chain can cause the pistols and valves to impact each other.
What would cause the engine fuse to continually blow in a 1983 Mazda 626?
Short to ground or overloaded circuit
