My guess would be a loose or disconected wire
chances are your flasher for the blinkers OS bad,the flasher for the hazzards are usually on different circits for emergency situations.
Possibly a defective Turn Signal Relay. Your four way flasher switch is probably bad. Your four ways will still work but not your blinkers.
You do not have to have blinkers on a motorcycle in Texas. If you do have blinkers they have to work properly. But if you DO NOT have blinkers you can still get the bike inspected and you will have to use hand signals or risk getting pulled over for not using hand signals.
you need to replace blinker can in your vehicle. the flashers and blinkers have separate flasher cans which is why your flashers still work but not your blinkers
Check two things: 1) the fuse for your flashers/blinkers and 2) that the bulbs are good still.
it may have nothing to do with your brake pads on my car the blinkers stoped working they still came on but they stoped blinking and i just had to repace the bulbs
I believe the flashers are on a separate fuse than the blinkers, that is where I would first start to look, is the fuse box
Most likely a fuse(s) check them all if you havn't already
It might be the switch itself.
Well, that depends on whether you still have the lights and blinkers, ect. If there are not lights, blinkers, brake lights, or horn, then you do not need a battery to run this bike. If you do have these items, then you would need a battery
you have bubbles in the tires you need to get a wheel balance 1st and 2nd wheel allignment if it still plays up or the engine is loose / old = more expsensive
The hot surface indicator light stays on to alert you that the surface is still hot and may cause burns or other hazards.