The fan turns on when the temperature sensor detects that the coolant is hot. Let the fan run for a while before you pull the fuse. If it's working properly, the fan should stop cycling after everything cools down. The coolant is probably heating from the residual engine heat, causing the fan to cycle back on. The fan is doing its job.
If it keeps doing that after everything has cooled down, you probably need a new sensor. Otherwise, everything is operating normally.
Beacuse its so hot, it will overheat if the radiator fan doesn't run after the engine is turned off. It usually will stop itself after 5 mins.
The drain plug for the radiator of a 2007 Dodge Caliber is typically located at the bottom of the radiator on the passenger side. It may be a small plastic or metal valve that can be turned or removed to allow coolant to drain. Always ensure the engine is cool before attempting to drain the radiator to avoid burns or injury.
no, but it can be turned off.
The radiator drain is turned counter clockwise to loosen.
And Then Nothing Turned Itself Inside Out was created on 2000-02-22.
WHEN I DID A FLUSH,I PUSHED IT IN AND TURNED IT, NOT SURE WHICH WAY, IT'S PLASTIC (MAKE SURE THE CAR HAS COOLED, THE COOLANT SHOOTS STRAIGH OUT AND MAY BE VERY HOT.
Leaking radiator? Leaking or loose radiator hose?
Leave it turned off.... doh
to make sure the temperature of the fluid in the radiator is cool enough
With a scan tool after repairing the code that turned it on.With a scan tool after repairing the code that turned it on.
The fan comes to cool the computer
The radiator drain plug should be close to the bottom of the radiator facing the engine. It could be a wing nut, or could be the type that is turned by a ratchet and extension.