It was the speed sensor. and it could also be the DRAC. Which is a speed sensor buffer that is located behind the dash to the left of the glove box. It is a white box.
To remove the gear shift knob on the '03 Silverado, first pry off the cover that has the shift pattern on it. Then, remove the screw that is under that cover to remove the knob.
If the 1999 Chevrolet Metro will not shift automatically there may be a problem with the transmission solenoid. The solenoid tells when the transmission when to shift, and when it is malfunctioning will cause a vehicle to stay stuck in a certain gear.
manual stick shift BMW what cause to shke when i change in to the first gear
if you have messed up the stiring wheel
The same thing happened to my dads 96 Chevy S-10. The transmission was rusted not allowing it to shift. I would have the transmission checked out.
The 1998 Chevy Silverado pickup truck shift solenoid can be found on the left-hand side of the engine. The shift solenoid will be near the center of the transmission.
Shift to a lower gear. Lugging will damage your engine and should not occur if you are in the proper gear for whatever you are doing. On your silverado if it is an automatic you should have a trailering button in the end of the gear shift to turn the trailering mode on and cause the vehicle to shift sooner when carrying a load even if you aren't pulling a trailer.
Your transmission might automatically shift out of overdrive while driving on the interstate because of low transmission fluid. This issue might also occur because of a bad transmission sensor or overdrive sensor.
To remove the shift cable on a 1998 Silverado with a 4L65E transmission, first, disconnect the negative battery terminal for safety. Then, locate the shift cable at the transmission and unclip it from the bracket. You may need to remove the retaining clip or bolt securing the cable to the transmission lever. Finally, pull the cable out of its housing to complete the removal.
There are several things that can cause your manual transmission not to shift out of first gear or reverse. The most common cause is a broken shifting fork.
shift
in the transmission, you have to drop the pan .