0
Need to check security fuse in fuse box, with a test light first. make sure its good.
Now read close. There is 3 simple steps to go through. this will take 33Min to do.
# 1 Turn key to start mode, as soon as you here the starter ingauge turn key loose
not off. Wait a 11 min. then turn key off. Do not wait, repete the same steps 2 more times for a 11 min. each. No longer or shorter then a 11 min. Then when you have
finished the last step and have turned the key off, Then start engine.
REMEMBER 11 MIN. ONLY EACH TIME.
What else can I help you with?
1998 camaro wont start could it be the security system?
yes
What will make the security light stay on in a 1999 S10 blazer it will start but will not stay running?
security light on 1998 s10 start but cut off
Names that start with d and ends with ck?
Duck
Resetting ck home security system?
You must consult the local distributor in your area
Can you get the veterans check if you draw a social security ck you are disabled?
Service connected only.
What words start with ck sound like k?
No words start with "ck" but a lot of words end with this particular combination of letters, such as brick, hijack, frock, luck, and check.
What is going on when your security light for a 1998 bravada blinks and car won't start?
if you have a "chipped " key, the security system is not recognizing the signal. Have you tried a spare key.?
Why will security system not allow car to start on Rav4 1998?
How to replace PVC valvle for Toyota Rav 4 2000?
How do you reset the security system in a 1998 Cadillac?
To reset the security system in a 1998 Cadillac, start by ensuring the vehicle is in the "OFF" position. Insert the key into the ignition and turn it to the "ON" position without starting the engine, and leave it for about 10 minutes until the security light turns off. Then, turn the key back to "OFF" and repeat the process two more times. After the third cycle, the security system should be reset, allowing you to start the vehicle.
What would cause a 97 Ford Probe to not have any power or not start at all?
ck and clean batt terminals ck fuse box under hood engine main fuse ck and clean batt terminals ck fuse box under hood engine main fuse
How do you reset the security light on a 1998 gmc Sonoma?
To reset the security light on a 1998 GMC Sonoma, you need to first ensure that the vehicle is in the "Off" position. Then, turn the ignition to the "On" position without starting the engine and leave it for about 10 minutes until the security light turns off. After that, turn the ignition back to "Off" and then start the engine. If the light remains on or the vehicle doesn't start, you may need to check the key or the vehicle's security system.
Why won't it start the first time but will start 20 minutes later?
ck fuel pressure,and bleed off pressure
