Mobil 1 synthetic
For a 2008 Cadillac DTS, it's recommended to use synthetic motor oil with a viscosity rating of 5W-30. This oil provides better protection and performance, especially in varying temperatures. Always check the owner's manual for specific recommendations and ensure compliance with GM specifications.
To reset the oil change light on a 2006 Cadillac DTS, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off and then start the engine; the oil life monitor should be reset. If the light remains on, repeat the process again.
7.5 qts
7.5 quarts with filter change
7.5 quarts
The Cadillac DTS typically requires about 6 quarts (or approximately 5.7 liters) of oil when equipped with a 4.6-liter V8 engine. It's important to check the owner's manual for the exact specifications, as oil capacity can vary slightly depending on factors like the type of oil filter used. Always ensure to check the oil level after filling to avoid overfilling.
Look on the cap, should be 10w 30
Just had the dealership change mine… It's a whopping 8 quarts!
The recommended type of motor oil for a 2007 Cadillac Escalade is 0w-30 Signature oil.
The 2006 Cadillac DTS typically uses 5W-30 engine oil. This weight is recommended for optimal performance and protection across various temperature ranges. Always check the owner's manual for specific recommendations and ensure the oil meets the required specifications.
The oil sending unit on a 2007 Cadillac DTS is located on the engine block, typically near the oil filter. It is often situated on the driver's side, towards the rear of the engine. To access it, you may need to lift the vehicle and remove any necessary components for better visibility and reach. Always consult a repair manual for detailed instructions and diagrams specific to your vehicle.
On a 2006 Cadillac DTS, the oil filter is located on the driver's side of the engine, underneath the car. It is positioned near the front of the engine block, making it somewhat accessible from the top or bottom. You may need to remove some components or shields to reach it easily. Always ensure the engine is cool and the car is securely lifted before attempting to change the oil filter.