No you don't. But you might want to replace the lower bushing also since you will be half way their. Also it is easier because you have to grind off the rivets to get the ball joint off the control arm. Most garages replace the control arm because labor rates compared to the cost of a new control is less expensive for the garage and customer. Also the liablity of the new ball joint has to be bolted on and not riveted as factory unit.
i would like to remove the backseat from my 1992 chevy cavalier
How do you remove and replace wiper switch on 2002 Chevy Cavalier
what are the signs for replacing the oil gasket in a 1996 Chevy cavalier
Its attached to the windshield wiper motor you will have to remove the cowl to get access to it.
where is the ignition control module loacted on a 1997 chevy cavalier
No
Remove the cover from your 1986 Chevy Cavalier radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
what does a bcm in a 2000 cavalier control
How to remove the dash board in a 2003 Chevy Cavalier. Center A/C vents not working and it squeaks all the time.
Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
how do you remove and replace the distributor cap on a 97 chevy cavalier?. I can not get to it.
remove glove box panel ecm is located behind panel