answersLogoWhite

0

What else can I help you with?

Related Questions

When should the timing belt be changed on a 1999 Chrysler Sebring Jxi convertible?

60,000 miles. This is an interference engine. If the belt breaks you will have serious engine damage.


When should you replace the timing belt on a 1999 Chrysler Sebring JXi Convertible?

100,000 miles


What type of oil should be used in a 2004 Chrysler sebring convertible?

5w30 but it depends on the size of your engine.


Where is the jack and lug wrench located on a Chrysler Sebring convertible?

They should be under the floor in the trunk, with the spare tire.


How long should labor take to replace a water pump in a 1996 Chrysler Sebring Convertible?

6 hours


Where is the dipstick on a Chrysler Sebring?

For a 1997 Sebring Convertible the oil dipstick is located just left of center towards the front of the car and should be labeled "engine".


How much should front and rear struts and shocks cost for a 2002 chrysler sebring convertible?

How much a front and rear struts and shocks cost for a 2002 Chrysler Sebring convertible varies based on the store, and brand of the part. In general, all together the parts can run $200 to $400.


What is the gas mileage for the Sebring Convertible?

Depending on how the car is drivenand which convertible, mileage can vary. But, according to Chrysler, this car should get 20 mpg in the city and around 27 on highway.


How often should the timing belt on a 1997 Chrysler Sebring be changed?

Every 100,000 miles.


What should the normal idle be on a V6 Chrysler Sebring Convertible at stop or rest?

The computer will set idle between 600 and 900 rpm depending on load and temperature..


How do you replace the rear rotors on a Chrysler Sebring convertible?

This change out should be fairly easy (compared to the front rotors). I changed out the rear rotor on a 2000 Sebring Convertible rather quickly. Buy the rotor at Autozone or o'Rielly and you will see that it justs slips over the lug nuts. The old one may take a little tapping around the edges to loosen it up. Use a gear puller in a worst case scenario. RB in Houston


Will 22 rims fit your 1997 Chrysler sebring convertible?

You may have to go to an auto parts store, they have mechanisms that you place between the springs to give it a small lift. If you do this, it should work with no problem.

Trending Questions
What does it mean when the Check engine light is on in 94 ford explorer sport? Lincoln town car questions How do I bypass the amp in my 97 Town Car if I want to put in a new AM FM CD Player Do I need to do anything with that weird amp? How can you test a fuel pump out of the tank? How do you remove the heater blower motor and fan from a 1998 Pontiac Bonneville you have confirmed the blower is the issue Can't find the room to remove the old parts? How do you adjust the flywheel on a 2004 Dodge? Where is the constant control relay module for 2002 mustang? Who plays Cadillac srx music? How do you replace Turn Signal Switch on a 67 Chevelle? Where are the rotor rivets on a 1980 Corvette? How do you fix the air conditioning if it only blows through the defrost and floor and not the vent in a 89 Chevy S10? How do you reset timing chain tensioner of 1998 cavalier 2.4? How much MORE hp will i get if i build a cold air intake on my 2004 dosge stratus sxt. 2.4 liter cheap ways to increase the hp? Where are some of the ways that one can make a car donation to NPR? Why is there sweet steam coming from engine? How much does it cost to replace a heater core in a 1997 Oldsmobile Bravada? How do you replace a side mirror on a Chevy Malibu? How do you repair a hole in the muffler on your 91 Chevy s10 truck? What is Jeep Grand Cherokee diagnostic code 72? Can the ac pulley and clutch be replaced on a 2000 ford excursion? How do you take the fan cluch off a 89 Ford Ranger to replace?