Bad A/C compressor clutch.
Bad A/C compressor clutch.
Bad bearing in compressor?
The first thing that you need to check will be to see if the both the a/c compressor and clutch are working as well as checking the condition of the drive belt............
When the compressor comes back on does it stay on?
the relays are on the engine side firewall. The compressor relay signal comes from the main computer through the pressure cycling switch or switches.
you need to put some freeon in it
Yes your compressor comes when you set your thermostat to "Fan" setting and you have it on cool setting.
What most likely is happening is the A/C compressor has gone bad and its not able to turn when it is switched on. The burning rubber smell is probably the belt sliding across the compressor pulley that's not turning.
Check for a blown fuse. If fuse is OK, see if the wiring at the compressor is OK. Clutch may also be defective. If the compressor comes on and off intermediately, it is low of refrigerant.
if the compressor dont come on when you turn on the a/c then your compressor could be bad, also there is a relay in the fuse panel for the a/c compressor is it has gone out then that could cause it if your compressor comes on then you might need to recharge your system
Yes if the compressor has oil in it, drain it out and measure what comes out. A good general rule is about 3-5 oz to put in the new compressor. Make sure to put it directly in the suction side(low side) of the compressor and turn it about 10 times .
In a car the heat usually comes from engine "waste heat". You just need to be running the engine. The compressor is part of the air conditioner, which is used for cooling not heating.
It depends on which temperature you have at the place where the air compressor is placed. But a normal air compressor takes 300 watt to run. The standard outlet which comes with your air compressor when you buy it will be good.