Disc brakes at the top of the caliper Drum brakes at the top of the wheel cylinder
Bleeder screw for clutch is at the slave cylinder, on the bell housing of the Transmission. The bleeder for the brakes is on the calipers, and on the backing plate of the rear drum brakes
The bleeder valve for the brakes on a 1997 Ford Ranger is located in the brake line where it meets the brake disc. The wheel will have to be removed to access the bleeder screw for drum brakes.
Doesn't have a cooling system bleeder valve.
The same way you bleed the brakes on any other Dot 3 or Dot 4 brake system vehicle. at the bleeder screws on the cylinders and or calipers
form_title= Ford F150 Brakes form_header= Drive safely with new brakes. When was the last time your brakes have been replaced?*= _ [50] Have you noticed any issues?*= () Yes () No Do you have to press hard on the brakes?*= () Yes () No
on the top or back of the caliper
Disc brakes? Start at the longer (Right front) Make sure master cylinder is full open bleeder screw at top of the caliper fluid should start to flow (gravity) When fluid is flowing have assistant step on brake pedal approx. 2/3 of travel and hold Tighten bleeder screw Repeat at left front
Either your brakes are sticking or they are adjusted to much.
Contaminated fluid? Frozen calipers?
Brake bleeder? Clutch bleeder? Coolant bleeder?
hand operated vacuum pump . hook up and and apply vacuum and open bleeder and keep applying vacuum then close bleeder. repeat x4
The hydraulic bleeder valve should be located on the drivers side (left) of the transmission up in a little hole with a rubber cover over the bleeder screw. Do not over tighten the screw or you will break it, then you would have to drop the transmission to replace it. Good luck.