0
In the front of the rear wheels and behind the front wheels. beyond the body flange to where the body bolts to the frame. There are jack point arrows along the body flange. A low profile jack is a must. The front may also be lifted under the cross member in th ecenter below the engine. Hera again you either need to drive up a slight ramp ( 2 - 2x12 pieces of wood work) or use a low profile jack)
What else can I help you with?
Where are the jack points on a 1998 Corvette?
The jack points on a 1998 Corvette are along the vehicle's frame, just behind the front wheels and in front of the rear wheels. They provide a secure point to jack the vehicle up.
How do to Jack up a 1998 Corvette?
The owner's manual will show you the points to place the jack. I suggest a floor jack and jack stands if you will be climbing under the car.
Where is the spare tire for a 1987 Corvette and the jack.?
Where is the spare tire located on a 1987 Corvette? Under the back of the car below the CORVETTE, use the lug wrench to lower it the jack is on top of the tire.
Where are the jack points on a c4 Corvette?
Right behind the front wheels and right in front of the back wheels. There are Vendors at Smokinvette.com that sell lifting pucks that are of great quality.
How do you replace the multifunction turn signal stalk on a 95 corvette Thanks.?
== ==
Points settings for 1969 corvette 350?
.019
Does a 1974 Corvette have points?
No, it is a pointless car! ;D
How much horsepower does a Corvette 95 HAVE?
300HP for the base model and 405HP for the ZR1
Can you put 16 wheels from a 1986 Corvette on a 1995 Corvette front end?
no. A 95 only has two wheels on the front. Sixteen will never fit.
Is this a Corvette block 14093638?
Not necessarily. It is a 350 V8 used in Chevrolet's from 87-95.
Where is the theft deterrent module on an 82 corvette?
it is under the plastcover where your jack are
How do you open the hood of a 95 corvette with a broken release cable?
There are hood tools. But if it is stuck, you might have to jack her up, remove the wheel, and back fender skirt. Then the fun begins. If it is broken at the hood connection, you will have to bend a metal rod to reach, and pull.
