looking down from (ONTOP) of the engine they are behind the water pump
In the 1989 Dodge Spirit, the timing marks for the engine can typically be found on the harmonic balancer and the timing cover. The harmonic balancer has a notch or a timing mark that aligns with the timing scale on the timing cover. For proper alignment, you may need to rotate the engine to the appropriate position (usually Top Dead Center) before checking the marks. Always refer to a repair manual for specific guidance on your engine type.
ssaaa
timing marks 1993 yoyota Camry 2200
there are no timing marks on a timing belt. the marks are on the timing gears and yes you can find the pictures needed in a workshop manuel
305 v8
yes you can use a 1996 lt4 engine into a 1989 Caprice Classic, and its easy. you can mail me at:
it has timing marks on it, look!
To set the timing marks on your 1989 Mazda B2200, first ensure the engine is at operating temperature and then turn off the engine. Locate the timing marks on the crankshaft pulley and the timing cover; align the crankshaft pulley mark with the "0" degree mark on the timing cover. Use a timing light connected to the number one cylinder's spark plug wire, and adjust the distributor until the timing light shows the correct timing specification according to your service manual. Finally, tighten the distributor bolts and recheck the timing to ensure it remains in alignment.
To set the timing on a 1989 Toyota Cressida, first ensure the engine is off and cool. Locate the timing marks on the crankshaft pulley and the timing cover, then use a timing light to check the current timing while the engine is running. If adjustment is needed, loosen the distributor hold-down bolt and rotate the distributor until the timing marks align correctly. Finally, re-tighten the distributor bolt and recheck the timing to ensure it's properly set.
To time your 1989 Chevy pickup, start by warming up the engine to its normal operating temperature. Locate the timing marks on the harmonic balancer and the timing tab on the engine block. Use a timing light to check the timing by connecting the light's clamp to the number one spark plug wire and aiming the light at the timing marks. Adjust the distributor as needed to align the marks with the specified timing degree, which is typically around 0° to 12° BTDC, depending on the engine model.
To set the ignition timing on your 1989 Dodge 318 V8, first, ensure the engine is at operating temperature and then turn it off. Locate the timing marks on the harmonic balancer and the timing tab. Use a timing light to illuminate the marks while the engine is running; adjust the distributor by loosening its hold-down bolt and rotating it until the timing mark aligns with the specified degree for your engine (typically around 12-14 degrees BTDC for stock). Once aligned, tighten the distributor bolt and recheck the timing.
To set the timing on a 1989 Mitsubishi pickup engine, first ensure the engine is at top dead center (TDC) on the compression stroke for cylinder one. Align the timing marks on the crankshaft pulley and the timing cover. Then, adjust the distributor until the timing light indicates the correct timing as specified in the service manual. Finally, tighten the distributor hold-down bolt and recheck the timing to ensure it hasn’t shifted.