answersLogoWhite

0

On my 99 Grand Prix 3.8 it's located below the rear exaust manifold on the engine block.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is a knock sensor located at on a 96 Pontiac Bonneville?

where is a knock sensor located on a 96 Pontiac Bonneville


Location of knock sensor on 2002 Pontiac grand prix?

location knock sensor 2002 pontiac grand prix gt 3.8 engine


Location of knock sensor for Pontiac G6?

The knock sensor for a Pontiac G6 is located on the side of the engine. It is mounted at the exhaust manifold.


Where to find knock sensor in a 1997 Chevy Lumina?

The knock sensor, in your 1997 Chevrolet Lumina, can be found on the front of the engine. The knock sensor is near the top of the engine.


What could be the reason for knock sensor 2 circuit low input bank 2 obd-ii code p0332 for the Pontiac firebird 1999 v6?

Usually means you need to change it.Same as o2 sensers.Low means change


Where is the Crankshaft Position Sensor on a 2000 Pontiac sunfire?

On the back side of the engine underneath to the left of the knock sensor which is to the left of the camshaft position sensor


What is the torque specs for a 2004 Chevy silverado knock sensor?

I found in a google search 15ftlbs torque for the knock sensor.


How do you find where your knock sensor is and how do you change it you have a 2001 Pontiac firebird 3.8?

look toward the back of your engine (jack the front end up and crawl under you can't see them from above) look on you passenger side it will should be white with a green wire running to it


Where is knock sensor on 6.0 liter 2005 pontiac gto engine?

on the lower part of the engine near the cats


Does a 94 integra have a knock sensor?

LS does not have a knock sensor. GSR does have a knock sensor


Would code 43 electronic spark control failure cause the vehicle to not start and would replacing the knock sensor fix this or is it an ECM issue?

I have a 1990 Pontiac Safari wagon that would not start,after much testing we found one bad fuel injector replaced it and car started but ran terrible, did more testing and found bad ignition module, replaced module runs better but now have code #43 knock sensor and engine is running in default mode switched ECM no help must be knock sensor don't think knock sensor would keep car from starting but the other things mentioned here would. Hope this helps. This wagon has 3.1 engine. Havent changed knock sensor yet.


What problems do the knock sensor indicate?

The knock sensor detects spark knock or ping.