Check on this web site: http://tss.likeabigdog.com/ Very detailed pictures and instructions.
The 2001 Monte Carlo emergency flasher relay switch and the turn signal flasher relay switch are the same. The flasher relay switch simply plugs in and out.
You probably need a new turn signal switch. I have a '96 Monte Carlo and I had to replace the turn signal switch to get the brake lights to work. Thankfully I had a brother who knew how to take off the steering column and replace. Hopes this helps!!!
To replace the turn signal switch on a 2003 Chevy Monte Carlo, first disconnect the negative battery cable to prevent any electrical shorts. Remove the steering column cover by unscrewing the necessary screws, then detach the airbag module if applicable. Next, unscrew the turn signal switch from the steering column and disconnect the wiring harness. Install the new switch by reversing the removal steps, ensuring all connections are secure before reassembling the steering column and reconnecting the battery.
When changing anything on a car, a person needs a diagram. A person can get an ignition switch diagram for this car, by buying the cars maintenance manual.
Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.
Check out this web site: http://tss.likeabigdog.com/
you will have to replace the complete ignition switch with a new one.
I had this problem with my Monte Carlo, I think it was that I needed a new turn signal switch. I think there was a sensor or something that was broke too?? But I believe the dash panel lights not working at night had something to do with a short in the turn signal switch.
The turn signal/hazard flasher is integrated into the flasher switch. A very common failure on these cars.
i have a 96 Monte Carlo and i had the same problem. try pulling the turn signal switch to you slightly while in the signal position. works for me every time.
the brakes are wired into the turn signal assembly. i had the same problem with my car the middle rear light would light up but not the left or right. if you wedge something in the turn signal you will notice your lights work. there actually was a recall on that part.the switch is actually on the brakes that's what makes them light up when you press it. if the wedge doesn't work then you will have to replace the whole turn signal switch located in steering collum. hope this helps
Begin by removing the retaining ring at the top of your 2001 Chevrolet Monte Carlo ignition switch. The ignition switch barrel will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.